LED Fog Machine

Attention

• Please obey all notices about operation. Safety and repair to avoid getting an electric shock and keep the excellent effect.
• Keep clean
• Use in door.
• The power must be the same as specified.
• Power off before adding fogger liquid.
• Place horizontally, do not incline or place upside down.
• Power off or pull out the plug after use.
• This product is not waterproof. If humidity, water, or fog liquid is present, switch off the power and contact the distributor immediately.
• No spare parts are included. For repairs, contact the distributor or professional repair services.

Avoid Fire

• For adult operation only. Keep out of reach of children and exercise caution during use.
• Do not spray directly at people or near open flames.
• The smoke temperature is high. Maintain a distance of over 100cm between the machine and other materials. (Machine surface temperature: 40-80°C; avoid touching).
• Place the machine in a well-ventilated area and do not cover cooling vents.
• Ensure a clearance of over 20cm between the machine and surroundings, and over 20cm from flammable materials. Keep easily combustible items at least 300cm away (e.g., carpets, boards, inflammable items).

Avoid Explosion

• Do not add flammable liquids like oil, gas, or perfume to the fog machine.
• Adhere to all notices, signs, and operating instructions.
• Use only high-quality fog liquid recommended by distributors. Inferior liquids may cause explosions or oil spray.
• Regularly check fog liquid levels.
• Empty the fog liquid tank before transporting or shipping.
• Do not ingest fog liquid. Seek medical attention immediately if ingested. Wash skin and eyes with clean water if contact occurs.

Package Check

• Open the carton and verify all necessary spare parts against the specification list. Contact the distributor if any parts are missing.
• Inspect the machine and power line for visible damage. Contact the distributor and discontinue use if damage is found.

Installation

• Remove all packing materials, especially the spray nozzle.
• Place the machine horizontally and open the liquid tank cover.
• Fill the machine with high-quality fog liquid and screw the tank cover back on. Using poor quality fog liquid can damage the machine.
• Connect the remote control cable to the socket on the back of the machine.

Operation

• Connect the power cord to an earthed power socket. Turn the switch to "On". The machine will begin heating. The green LED on the remote console will illuminate when heating is complete.
• Press the red button to spray fog. Press and hold for continuous spraying.
• The red LED on the remote console indicates the machine's status: lit means spraying, unlit means heating.
• The machine can be mounted or placed on the ground. Avoid spraying directly at people. The tilt angle should not exceed 15°.
• Monitor the fog liquid level regularly. Operating the machine with insufficient liquid can cause significant damage.
• If fog output is low, the machine makes noise, or no fog is produced, power off and check the fog liquid, fuse, remote connector, and power plug. If the issue persists, contact the distributor for repair.

Maintenance and Repair

Clean the fog machine regularly to prevent damage and reduce repair costs.

• Keep the machine clean. Secure the liquid tank cover after adding liquid.
• After approximately 40 hours of continuous use, clean the internal pipe with a mixture of 80% distilled water and 20% vinegar.
• Disassemble and clean the spray nozzle with vinegar before heating to ensure it is clear. Reassemble the nozzle after it cools and refill with fog liquid for the next use.

Technical Parameters

Control Mode

Control mode: Wired remote control / Wireless control

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Unauthorized modifications may void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, per FCC Rules Part 15. These limits are intended to provide reasonable protection against harmful interference in residential installations. The equipment generates, uses, and can radiate radio frequency energy. If not installed and used as instructed, it may cause harmful interference to radio communications. While interference is not guaranteed to not occur, if it does, users are encouraged to correct it by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the receiver.
• Consult the dealer or an experienced radio/TV technician.

The device meets general RF exposure requirements and can be used in portable exposure conditions without restriction.