Rollerhouse DC12V 500mA 2 Wires Hard Wired Switch Controlled Electric Roller Blind/Shade Motors for 21mm/28mm RV Roller Shade, Convert Existing Blinds into Automated Blinds : Tools & Home Improvement
16mm/25mm Tubular Motor (DC12V) Switch Controlled System Instrucon Please fell free to contact us if you have any queson regarding programming or installaon please contact Eamil: service@rollerhouses.com Operaon Technical Data Item Operaon Result Illustraon Model&Voltage: ES1612 ES2512 DC12V Torque&Speed: 0.3Nm/25rpm 0.7Nm/34rpm Power Supply: 12V DC Li Capacity: 4.4lb/2kg under 3/4inch/1inch roller tube 6lb/3kg under 1.18inch roller tube, 5.5lb under 1.5 inch roller tube Set up the motor The switch-controlled motors have build in electronics to memorize the upper and lower set-limits for the shades aer the inial seng in"Ignion ON" mode and "Ignion OFF" mode NOTICE:Illustraon Shows the side of the motor head with SETTING buon should be face to you Install motor terminal on the same side as power supply. UP Install brackets unl the motor is horizontal. Adapter Motor The motor has no build in RF receiver, can't control with Seng Key remote directly, can connect with any three posion switch and Easy to any home automaon The motor connecons determine motor running direcon, Ulize a DPDT momentary ON-OFF-ON switch Wiring Please Connect terminal 1 with terminal 6; Terminal 2 with terminal 5 1 Connect the motor with the switch of DC 12V power supply Turn the coach ignion ON Motor Wire(white) Switch Motor Wire(white) DC12V Press and hold the rocker switch to "" Motor programming 1 or ""to get the roller motor power on Press the learning key on the motor The The motor will beep to enter the program state motor will beep to enter the program UP STOP DOWN state Check motor direcon 1 Press UP buon,If blind goes up the motor direcon is ok (If necessary 2 To change direcon if the blind goes down then the motor direcon should be changed Please switch between 3 wires and 4 wires upper limit lower limit OK 2 Keep the switch in the UP state Motor runs up connuously Set upper Limit Setup boom limit Trouble shoong 3 Press STOP buon when the shade reaches approximate desired upper limit Motor stops OK 4 Press UP buon and then STOP buon on the switch if needed 5 Motor will stay in program mode,press the Down poson Motor runs small step by step to adjust upper limit accurately Motor beeping and runs down 6 Press STOP buon when motor gets close to the end-point of the lower limit Motor stops 7 Press DOWN buon and then stop buon if needed Motor runs small step by step to set lower limit accurately 8 If you want to reset the motor limit please start all the steps from the first step If nothing works, please check: Whether the power supply is connected properly and well ghtened. If yes, the motor will beep If the motor connues running, please check: Whether the motor connues running in one direcon, it refers customers are failed limit seng and need to reset again.Adobe PDF library 15.00