Disassembling SKIL 4235 Jigsaw Base plate

Disassembling SKIL 4235 Jigsaw Base plate - iFixit

Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward.

PDF preview unavailable. Download the PDF instead.

19751
Disassembling SKIL 4235 Jigsaw Base p...

Guide ID: 19751 - Draft: 2019-02-11

Disassembling SKIL 4235 Jigsaw Base plate
To instruct the use in how to disassemble the base plate to allow further access to disassembling the device.
Written By: Adam Cardoso

This document was generated on 2020-11-23 11:12:42 AM (MST).

© iFixit -- CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Disassembling SKIL 4235 Jigsaw Base p...
INTRODUCTION

Guide ID: 19751 - Draft: 2019-02-11

This guide is to remove the base plate. This will allow you to access the rest of your saw and disassemble it properly.

TOOLS:
Phillips #2 Screwdriver (1)

This document was generated on 2020-11-23 11:12:42 AM (MST).

© iFixit -- CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Disassembling SKIL 4235 Jigsaw Base p...
Step 1 -- Disassembling SKIL 4235 Jigsaw Base plate

Guide ID: 19751 - Draft: 2019-02-11

 Orient your saw so that the blade is pointing in the opposite direction of your body. Ensure that the screws circled are visible and pointing skyward. This will be the standard position of the Jigsaw for the duration of this guide.

Step 2

 Using two hands grip both side of the saw and lay on side.

This document was generated on 2020-11-23 11:12:42 AM (MST).

© iFixit -- CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Disassembling SKIL 4235 Jigsaw Base p...
Step 3

Guide ID: 19751 - Draft: 2019-02-11
 With bottom of the base plate visible, identify one M4 screw circled in red and remove with Phillips screwdriver (some models have flathead screw, as pictured, and require flathead screwdriver).

This document was generated on 2020-11-23 11:12:42 AM (MST).

© iFixit -- CC BY-NC-SA

www.iFixit.com

Page 4 of 5

Disassembling SKIL 4235 Jigsaw Base p...
Step 4

Guide ID: 19751 - Draft: 2019-02-11
 After removing M4 screw, remove the base plate and place to the side. Don't forget to replace the M4 screw near the base plate during reinstallation.

To reassemble your device, follow these instructions in reverse order.

This document was generated on 2020-11-23 11:12:42 AM (MST).

© iFixit -- CC BY-NC-SA

www.iFixit.com

Page 5 of 5


wkhtmltopdf 0.12.5 Qt 4.8.7