Urbanista Lisbon User Manual

Introduction

Thank you for choosing an Urbanista product.

First Time Pairing and Reconnecting

To connect the earphones to a Bluetooth device for the first time, open the charging case whilst the earphones remain inside the case. The earphones will automatically enter pairing mode. Open Bluetooth settings on your device and select "Urbanista Lisbon" to connect. If pairing is not established within 5 minutes, pairing mode is canceled and the procedure must start over. The earphones will automatically reconnect to the same device you have paired them with when next turned on.

Connect to Another Device

Disconnect the earphones from the device to enter pairing mode again or to connect to another device. The earphones can store up to six paired devices.

Charging and Battery

The earphones will automatically start charging when put back into the charging case. A "low battery" voice prompt will notify you when there are approximately 30 minutes of playtime remaining, after which the earphones will automatically turn off.

Use the included USB Type-C cable connected to a power source to charge the case. The "Battery Status Indicator" (1) will pulse during charging and continuously lit when the case is fully charged.

• 0-35%: The LED pulses red
• 35-70%: The LED pulses white
• 70-100%: The LED is lit white continuously

When not charging the case, simply open the lid to see the status of the charging case battery.

GoFit Silicone Wings

The included silicone wings can be used for a secure fit.

Reset

1. Delete the "Urbanista Lisbon" from the Bluetooth settings on your device.
2. Press and hold the "Reset Button" (2) for 10 seconds, whilst the earphones remain inside the case, until the "Battery Status Indicator" (1) flashes red quickly before turning white for 3 seconds. Close the charging case to successfully complete the reset. The reset can only be done while the case is open.
3. Follow the instructions in "First Time Pairing and Reconnecting" to reconnect to your earphones.

Controls

• PLAY/PAUSE: Tap the left (L) or right (R) earphone twice.
• NEXT TRACK: Touch and hold the right (R) earphone for 2 seconds.
• VOLUME UP: Tap the right (R) earphone once.
• VOLUME DOWN: Tap the left (L) earphone once.
• ANSWER INCOMING CALL: Tap the left (L) or right (R) earphone twice.
• END CALL: Tap the left (L) or right (R) earphone twice.
• REJECT A CALL: Touch and hold the left (L) or right (R) earphone for 2 seconds.
• VOICE ASSISTANT: Touch and hold the left (L) earphone for 2 seconds.

Troubleshooting

If you have any additional questions, please visit our online help center where you will find our FAQs and an online version of this manual: https://support.urbanista.com/

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

RF Exposure Information

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

ISED Statement

English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

The digital apparatus complies with Canadian CAN ICES - 3 (B)/NMB - 3(B).

French: Cet appareil contient des émetteurs/récepteurs exempts de licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Développement économique Canada.

L'exploitation est soumise aux deux conditions suivantes :

1. Cet appareil ne doit pas provoquer d'interférences.
2. Cet appareil doit accepter toute interférence, y compris les interférences susceptibles de provoquer un fonctionnement indésirable de l'appareil.

L'appareil numérique du ciem conforme canadien peut 3 (b) / nmb 3 (b).

This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du cnr 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des données canadiennes sur l'exposition aux champs rf et la conformité.

This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.

Cet équipement est conforme aux limites d'exposition aux rayonnements du Canada établies pour un environnement non contrôlé.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

L'appareil a été évalué pour répondre aux exigences générales d'exposition aux radiofréquences. L'appareil peut être utilisé en condition d'exposition portable sans restriction.

Specific Absorption Rate (SAR) Information

This Urbanista Lisbon meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.

The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC/IC RF Exposure Information and Statement the SAR limit of USA (FCC) /IC(ISED)is 1.6 W/kg averaged over one gram of tissue. Device types: Urbanista Lisbon has also been tested against this SAR limit. This device was tested for typical head operations with the earphone kept 0mm from the head. To maintain compliance with FCC/IC RF exposure requirements, use accessories that maintain an 0mm separation distance between the user's head and the earphone. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC/IC RF exposure requirements, and should be avoided.

Informations sur le débit d'absorption spécifique (DAS):

Cette Urbanista Lisbon répond aux exigences du gouvernement en matière d'exposition aux ondes radio. Les lignes directrices sont basées sur des normes élaborées par des organisations scientifiques indépendantes à travers une évaluation périodique et approfondie des études scientifiques. Les normes comprennent une marge de sécurité substantielle conçue pour assurer la sécurité de toutes les personnes, quel que soit leur âge ou leur état de santé. Information et déclaration d’ISDE sur l'exposition aux RF la limite DAS du Canada (ISDE) est de 1,6 W / kg en moyenne sur un gramme de tissu. Types d'appareils: L'urbaniste de Lisbonne a également été testé en fonction de cette limite SAR. Cet appareil a été testé pour des opérations typiques de tête avec l'oreillette à 0mm de la tête. Pour être conforme aux exigences d'exposition RF du FCC/IC, utilisez des accessoires qui maintiennent une distance de séparation de 0mm entre la tête de l'utilisateur et l'oreillette. L'utilisation de clips de ceinture, d'étuis et d'accessoires similaires ne doit pas contenir de composants métalliques dans son assemblage. L'utilisation d'accessoires qui ne satisfont pas à ces exigences peut ne pas être conforme aux exigences d'exposition aux RF d'ISDE et doit être évitée.