Sharkoon REBEL C70G ATX PC Case

Manual

Specifications

Category	Detail
General
Form Factor	ATX
Expansion Slots	7
Interior Painting	✔
Graphics Card Holder	✔
Cable Management System	✔
Side Panel	Tempered Glass
Color Versions	Black
Dimensions (L x W x H)	47.9 x 23.0 x 49.5 cm
RGB Compatibility
Type	Addressable
Ports	8
Manual Control	22 Modes
Mainboard Compatibility	MSI Mystic Light Sync, ASUS Aura Sync, Gigabyte RGB Fusion Ready, ASRock Polychrome Sync
RGB Pinout	5V-D-coded-G
Max. Drive Bays
3.5"	3
2.5"	3
I/O
Type-C (USB 3.2 Gen 2)	1
USB 3.0 (Top)	2
Audio (Top)	✔ (TRRS)
Fan Configuration
Front Panel	3x 120 mm Addressable RGB LED PWM Fan (Pre-installed) or 3x 140 mm Fan (Optional)
Rear Panel	1x 120 mm Addressable RGB LED PWM Fan (Pre-installed)
Top Panel	3x 120 mm or 2x 140 mm Fan or Radiator (Optional)
Side Panel	4x 120 mm Fan* or Radiator (Optional)
Compatibility
Mainboard	Mini-ITX, Micro-ATX, ATX
Max. Length Graphics Card	40.0 cm
Max. Height CPU Cooler	16.5 cm
Max. Length PSU	27.0 cm
Max. Height Radiator incl. Fan (Top)	6.0 cm
Package Contents	Rebel C70G RGB, Accessory Set

*1x 120 mm fan has same installation space for 1x HDD

Side Panel Assembly

The diagram shows the rear of the PC case. An arrow indicates that the side panel should be pulled outwards from the rear, suggesting a latch or clip mechanism for removal.

Install 2.5" HDDs/SSDs

The diagram illustrates the installation of 2.5-inch drives. Yellow brackets are shown being attached to mounting points within the PC case using screws. The 2.5-inch drives are then secured to these brackets with screws. Arrows indicate the direction of insertion and tightening.

Install 3.5" HDDs

This diagram shows the installation of 3.5-inch drives. Similar to 2.5-inch drives, brackets are used, and screws secure the drives. Arrows indicate the mounting process.

Install PSU

The diagram shows the Power Supply Unit (PSU) being installed into its bay at the bottom rear of the case. Screws are used to secure it. Arrows indicate the direction of insertion.

Detachable Dust Filter

These diagrams illustrate the process of removing and reinserting the detachable dust filters. Arrows indicate pulling the filters out from the front and bottom of the case.

Adjustable Graphics Card Holder

The diagram shows the adjustable graphics card holder being installed. It attaches to the case's motherboard tray area. Screws secure the holder, and an adjustable arm supports the graphics card. Arrows indicate the movement and attachment points.

Install Fans

These pages detail fan installation. Diagrams show mounting 120mm and 140mm fans to the front, top, and side panels of the case. Screws are used for attachment. Arrows indicate airflow direction and mounting points.

Install Radiator

These pages illustrate radiator installation. Diagrams show radiators of various sizes (120mm, 140mm, 240mm, 280mm, 360mm) being mounted to the top and side panels of the case. Screws are used for securing the radiators. Arrows indicate mounting and airflow.

Optional Vertical Graphics Card Kit

This section mentions an optional kit for mounting a graphics card vertically. It advises checking with a local dealer for availability and lists two models: REBEL C Series Vertical Graphics Card Kit 4.0 Black and REBEL C Series Vertical Graphics Card Kit 4.0 White, along with their respective product codes.

Addressable RGB Control

Control through Mainboard

Diagram shows a SATA power connector and a 5-pin RGB connector from the addressable RGB LED strips/fans connecting to the motherboard's addressable RGB pin header. The pin header is labeled with +5V, D (Data), and GND. A separate inset shows a connection to a reset switch.

Manually Control Addressable RGB

Diagram shows a SATA power connector and a reset switch connection. A circular diagram illustrates various RGB color modes (Red, Green, Blue, White, Yellow, Cyan, Pink, Natural White, Warm White) and sequences, labeled as RGB Mode 1 through 13. Instructions state that the reset switch cycles through modes, and holding it for 2 seconds turns LEDs off, while pressing it again turns them on.

Notes

Legal Disclaimer

For potential loss of data, especially due to inappropriate handling, Sharkoon assumes no liability. All named products and descriptions are trademarks and/or registered trademarks of the respective manufacturers and are accepted as protected. As a continuing policy of product improvement at Sharkoon, the design and specifications are subject to change without prior notice. National product specifications may vary. All rights reserved especially (also in extracts) for translation, reprinting, reproduction by copying or other technical means. Infringements will lead to compensation. All rights reserved especially in case of assignation of patent or utility patent. Means of delivery and technical modifications reserved.

Disposal of your old products

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol ?️ is attached to a product, it means the product is covered by the European Directive 2012/19/EU. Please be informed about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences to the environment and human health.

Follow us on

Sharkoon Technologies GmbH
Grüninger Weg 48
35415 Pohlheim
Germany

CE, UKCA markings are present.

	Sharkoon REBEL C50 ATX PC Case - User Manual and Specifications Comprehensive guide for the Sharkoon REBEL C50 ATX PC Case, covering detailed specifications, installation instructions for fans, storage, PSU, radiators, and RGB lighting control, along with legal information and disposal guidelines.
	Sharkoon Rebel C80M ATX PC Case Manual User manual for the Sharkoon Rebel C80M ATX PC Case, detailing specifications, assembly instructions, fan and radiator installation, RGB control, and compatibility.
	Sharkoon MK2 & MK2 RGB Micro-ATX PC Case Manual Comprehensive manual for Sharkoon MK2 and MK2 RGB Micro-ATX PC cases, covering specifications, safety guidelines, detailed assembly instructions for components, fans, radiators, and RGB lighting control.
	Sharkoon VK2 ATX PC Case - Features and Specifications Detailed overview of the Sharkoon VK2 ATX PC case, highlighting its spacious design, expandable airflow, water-cooling support, storage options, connectivity, and compatibility with large hardware components. Includes technical specifications.
	Sharkoon MK3 and MK3 RGB Micro-ATX PC Case User Manual and Specifications Comprehensive guide to the Sharkoon MK3 and MK3 RGB Micro-ATX PC cases, covering specifications, safety instructions, installation steps for drives, fans, radiators, and RGB lighting control.
	Sharkoon VK4 Rainbow PC Case Manual and Specifications Comprehensive manual and technical specifications for the Sharkoon VK4 Rainbow PC case. Includes detailed installation guides for drives, expansion cards, and cooling, safety instructions, compatibility details, and legal information.
	Sharkoon VK4 Rainbow ATX PC Case Manual Comprehensive manual for the Sharkoon VK4 Rainbow ATX PC Case, detailing specifications, installation procedures for storage devices, expansion cards, fans, and radiators, along with essential safety guidelines and product disposal information.
	Sharkoon VK2 RGB ATX Case: Features, Specifications, and Compatibility Detailed overview of the Sharkoon VK2 RGB ATX computer case, highlighting its gaming design, expandable airflow, water-cooling support, storage capacity, connectivity, and hardware compatibility. Includes full specifications and package contents.