Westinghouse WST3750 2-PC Sound System

Using the LINE Inputs

To use the LINE inputs, insert the 3.5mm end of either of the supplied audio cables (3.5mm or RCA to 3.5mm) to one of the LINE IN input jacks on the side of the soundbar. Attach the other end of the audio cable to the 3.5mm jack or RCA input jack on your media playing device.

The soundbar will automatically switch to the LINE IN and the corresponding LED indicator will turn RED/BLUE. To switch to and from the LINE inputs, press the [MODE] button on the side of the soundbar or on the remote control.

Legal Information

READ CAREFULLY AND KEEP THIS MANUAL

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

WARNING Rain/Moisture:

• Do not expose the unit to extreme temperatures (heat or cold), open flames, humid conditions, or wet conditions.
• Do not submerge in water.
• Do not open this product or attempt to repair the unit yourself should it not be working.

Limited Warranty

90 Days Limited Warranty

In the unlikely event that this product is defective, or does not perform properly, you may within ninety (90) days from your original date of purchase return it to the authorized service center for repair or exchange.

TO OBTAIN WARRANTY SERVICE:

• Call the Customer Support number located below, or go to our website portal to receive an SRO number.
• Provide proof of the date of purchase within the package (dated bill of sale).
• Prepay all shipping costs to the authorized service center, and remember to insure your return.
• Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective unit within the package.
• Describe the defect or reason you are returning the product.

Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will require you to file a claim with the carrier.

The shipping address of the authorized service center is:

Customer Service Dept. 36
c/o Southern Telecom
400 Kennedy Drive
Sayreville NJ 08872

Should you have any questions or problems concerning this product, please contact our customer service department at:

Customer Support:
Phone: 1-877-768-8481
Monday - Friday 8AM-10PM (EST)
www.southerntelecom.com
Click on Product Support

Limited Warranty (cont'd)

Warranty service not provided:

This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, and unauthorized modification. This warranty is voided in the event any unauthorized person opens, alters or repairs this product. All products being returned to the authorized service center for repair must be suitably packaged.

Limitation of Warranty:

• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION GIVEN BY AIT, INC. ITS AGENTS, OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. AIT, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHNTIBILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.

Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts so the above limitations on exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights that vary from state to state.

WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation. Used under license by Southern Telecom, Co. All Rights Reserved.

Westinghouse

2-PC Sound System

WST3750

A compact black subwoofer is depicted.

In the Box

Soundbar

Subwoofer

Remote Control

Mounting Screws x2

RCA to 3.5mm Auxiliary Cable

DC-14V Power Adapter x2

3.5mm Auxiliary Cable

Location of Controls

(Front)

1. LINE IN 1 LED Indicator

2. LINE IN 2 LED Indicator

3. Bluetooth Indicator

4. Infrared Receiver Panel

5. [POWER] Button: Quick Press - Power ON/OFF

6. [MODE] Button: Quick Press - Change input mode

7. [VOL-1] Button: Quick Press - Skip to previous track, Long Press - Decrease volume

8. [II] Button: Play/pause media playback

9. [VOL+] Button: Quick Press - Skip to next track, Long Press - Increase volume

10. LINE IN 1 Jack (3.5mm AUX)

11. LINE IN 2 Jack (3.5mm AUX)

12. DC-14V Power Jack

(Side)

The side view shows the location of the DC-14V Power Jack.

Setting up the Speaker

Powering the Soundbar and Subwoofer

Attach the pin of one of the supplied power adapters to the DC-14V power jack on the soundbar. Plug the adapter into a working wall outlet. Attach the pin of the other supplied power adapter to the DC 14V power jack on the subwoofer. Plug the adapter into a working wall outlet. Move the subwoofer's [POWER] switch to the ON position.

The subwoofer will automatically connect, wirelessly to the soundbar when both are powered ON.

Mounting the Speaker

1. Measure a width of 31.8175 inches on the wall and mark the position of the mounting screws on the wall using a pencil.
2. Drill the mounting screws directly into the pencil-marked locations. Allow the screws to protrude approximately 0.3 inches out of the wall so you can easily hook the soundbar onto them.
3. Place and slide the soundbar onto the mounting screws. Carefully make sure it is firm and stable.

Replacing the Remote Control Battery

To replace or install the battery, push and slide the battery door out from the remote control. Replace the battery with a new CR2025 battery with the positive (+) polarity facing up.

NOTE: When using for the first time, gently pull the protection tab extending out of the remote control's battery door.

Pairing the Speaker

1. Quick press the [POWER] button. The Bluetooth LED indicator will flash BLUE and RED and a voice will be heard.
2. Set your mobile device to search for Bluetooth devices. When your mobile device finds the speaker, select WST3750 from the list of found devices.
3. After a successful pairing, a tone will be heard and the Bluetooth LED indicator will flash BLUE.

On an iPhone or Android Device

• Go to SETTINGS -> BLUETOOTH

A visual representation of a smartphone displaying Bluetooth settings and a successful pairing confirmation is described.

The screenshots above are typical of many Bluetooth-enabled devices in the market today, and are used to assist in the explanation of the pairing process. Your Bluetooth-enabled device's interface and interaction with the Bluetooth speaker may differ slightly from the illustrations above.

To maintain the Bluetooth connection, keep your Bluetooth-enabled device within 30 feet of the speaker.

Using the Speaker

NOTE: Please go through the Setting Up the Speaker section of this user guide.

Powering ON/OFF

• Quick press the [POWER] button on the side of the soundbar to turn ON/OFF.
• Quick press the [POWER] button on the subwoofer to the ON/OFF position to turn the speaker ON/OFF.
• Press the [Standby] button to put the soundbar in standby mode.

Adjusting Volume

Long press the [VOL-1] (decrease) and [VOL+ |►►1] buttons on the side of the soundbar to adjust volume or use the [/P-] and [►►I/P+] buttons on the remote control.

Changing Modes

The speaker can switch between Bluetooth and two LINE IN input modes. Once the soundbar is paired to a Bluetooth device and an AUX-in jack is wired to a media-playing device, quick press the [MODE] button to switch between these inputs.

NOTE: For further info on pairing Bluetooth devices to the soundbar see the Pairing the Speaker section of this user guide. For further info on using the LINE inputs, see the Using the LINE Inputs section of the user guide.

Playing Music

To enjoy music wirelessly on your soundbar, make sure that the soundbar is properly paired to your mobile device. If you are pairing the device for the first time, please consult the Pairing the Speaker section of this user guide.

Playing/Pausing Music

Press the [II] button on the side of the soundbar or on the remote control to play/pause media playback.

Using the Speaker (cont'd)

Skipping Tracks

Quick press the [VOL-] button on the speaker or the [/P-] button on the remote control to skip to the next track.

Quick press the [VOL+1] button on the speaker or the [/P-] button on the remote control to skip to the previous track.

Using the Remote Control

The remote control allows full control of music playback and volume adjustment.

• [POWER] Button: Enter/leave standby
• [INPUT] Button: Change input mode
• [/P-] Button: Skip to previous track
• [II] Button: Play/pause music
• [/P+] Button: Skip to next track
• [TREBLE-]/[TREBLE+] Buttons: Adjust treble volume of speaker
• [BASS-]/[BASS+] Buttons: Adjust bass volume of speaker
• [VOL-]/[VOL+] Buttons: Adjust overall volume of speaker

NOTE: If the speaker is not responding to the remote's button presses, the batteries may need to be changed. See the Replacing the Remote Control Battery section, earlier in this user manual.

Please consult the Replacing the Remote Control Battery section under the Setting up the Speaker section of this user guide for further info on setting up the remote control.

NOTE: When using the remote control, for best results point directly at the infrared receiver panel on the front corner of the soundbar.