LGK780 The Going Merry Pirate Ship Model Kit

Introduction

Welcome to the assembly of the LGK780 The Going Merry Pirate Ship model. This guide provides step-by-step instructions to help you construct your detailed replica.

Before You Begin

Ensure you have all components and necessary tools before starting. Lay out all parts in a well-lit area.

Parts Check

Verify all parts are present and undamaged. Refer to the included parts list (not detailed here) to confirm quantities.

Tools Recommended

• Hobby knife or precision cutter ?
• Tweezers ?
• Craft glue (suitable for plastic models)
• Small screwdriver (if applicable)

Assembly Steps

Step 1: Hull Base Assembly

Take the main hull base piece (Part A). Attach the two side hull panels (Parts B1 and B2) to the designated slots on the base. Ensure a snug fit. Apply a small amount of glue to the connecting edges for a secure bond. ➡️ Check alignment before the glue sets.

Step 2: Internal Structure

Insert the internal support beams (Parts C1, C2, C3) into the pre-molded slots within the hull. These provide structural integrity. ➡️ Ensure the beams are flush with the hull interior.

Step 3: Deck Installation

Place the main deck piece (Part D) over the assembled hull. Align the tabs on the deck with the corresponding notches on the hull sides. Press down gently until it clicks into place or is ready for gluing. ➡️ The deck should sit level.

Step 4: Captain's Cabin Construction

Assemble the captain's cabin structure using parts E1 (base), E2 (walls), and E3 (roof). Attach the walls to the base, then secure the roof. ➡️ Refer to the diagrammatic representation for window placement (textual description: the cabin has square openings on its sides for windows).

Mount the assembled cabin onto the designated area on the main deck. ➡️ Ensure it is centered.

Step 5: Mast Assembly and Attachment

Assemble the main mast by connecting the lower section (Part F1) and upper section (Part F2). Slide the mast into the central hole on the deck. ➡️ Secure from underneath if required by the design.

Step 6: Sail Attachment

Carefully attach the fabric sails (Parts G1, G2, G3) to the masts and rigging lines. Use the provided small clips or loops. ➡️ Ensure sails are taut but not overly stretched.

Step 7: Adding Details

Attach smaller details such as railings (Parts H1-H6), cannons (Part I), and the ship's wheel (Part J) to their respective locations on the deck and hull. ➡️ Pay close attention to the orientation of each piece.

Step 8: Final Touches

Perform a final inspection of the entire model. Ensure all parts are securely attached and aligned correctly. Your Going Merry Pirate Ship is now complete! ✔️

Care and Display

Display your completed model in a safe location away from direct sunlight or extreme temperatures. Dust gently with a soft brush.