Assembly Instructions: Round Table

General Warnings & Recommendations

Important: Two people are recommended for assembly (X2).

When using an electric screwdriver, reduce the power and torque settings to avoid damaging the furniture.

Follow the instructions carefully to ensure correct assembly.

Place the table on a soft, protective surface, such as a rug, to prevent scratches and reduce the risk of tip-over.

Parts & Hardware List

Parts:

• Part 1: Tabletop Segments (4 pieces)
• Part 2: Inner Support Structure (1 piece)
• Part 3: Middle Ring (1 piece)
• Part 4: Central Column Base (1 piece)
• Part 5: Bottom Ring (1 piece)
• Part 6: Curved Support Legs (8 pieces)

Hardware:

• Hardware A: M6x18mm screws (8 pieces + 1 spare)
• Hardware B: M6x35mm screws (52 pieces + 1 spare)
• Hardware C: φ8*30mm bolts/dowels (8 pieces + 1 spare)
• Hardware D: Caps/Covers (6 pieces)
• Hardware E: Allen key (1 piece)

Caution: Ensure all parts are included. Most board parts are labeled or stamped on the raw edge. Contact the manufacturer for free replacement if any parts are damaged or missing.

Assembly Steps

Step 1: Assemble Tabletop Segments

Take the four Part 1 tabletop segments. Align them and connect them using four pieces of Hardware C (φ8*30mm bolts/dowels).

Step 2: Complete Tabletop Assembly

Join the four connected Part 1 segments to form the complete circular tabletop. Secure them using a total of four pieces of Hardware C (φ8*30mm bolts/dowels).

Step 3: Attach Inner Support Structure

Place Part 2 (Inner Support Structure) onto the underside of the assembled tabletop. Secure it using twelve pieces of Hardware B (M6x35mm screws).

Step 4: Attach Support Legs to Base

Attach the eight Part 6 (Curved Support Legs) to the Part 4 (Central Column Base). Use eight pieces of Hardware A (M6x18mm screws) for this step. This completes approximately 75% of the leg assembly.

Step 5: Connect Pedestal to Middle Ring

Connect the assembled pedestal (from Step 4) to Part 3 (Middle Ring). Secure this connection using sixteen pieces of Hardware B (M6x35mm screws). This stage is approximately 75% complete.

Step 6: Connect Pedestal to Bottom Ring

Connect the assembly from Step 5 to Part 5 (Bottom Ring). Secure this connection using sixteen pieces of Hardware B (M6x35mm screws). This completes the pedestal structure (100%).

Step 7: Attach Pedestal to Tabletop

Carefully attach the completed pedestal assembly to the underside of the tabletop assembly. Use eight pieces of Hardware B (M6x35mm screws) and six pieces of Hardware D (Caps/Covers) for this final connection.

Step 8: Final Assembly

The table is now fully assembled.

Step 9: Usage and Safety Guidelines

Weight Capacity: The table is designed to support weight distributed evenly. Ensure loads are placed centrally and do not exceed the table's capacity.

Load Limits: Do not place excessive weight on the table or allow it to tilt. Avoid placing heavy objects near the edge.

Usage Restrictions: Do not sit or press on the table side. The table is not intended for seating or as a climbing surface.