User Guide for tp-link models including: Tapo L9XX, Multicolor Smart Light Strip, Tapo L9XX Multicolor Smart Light Strip, Smart Light Strip, Light Strip
Quick Start Guide. Tapo Smart Light Strip, Multicolor. ©2021 TP-Link 7106509328 ... For technical support, the user guide and other information, please visit https.. View
Support | Tapo
File Info : application/pdf, 2 Pages, 196.07KB
DocumentDocumentQuick Start Guide Tapo Smart Light Strip, Multicolor ©2021 TP-Link 7106509328 REV1.0.0 *Images may differ from actual products. Set Up Your Light Strip STEP 1 DOWNLOAD APP Get the Tapo app from the App Store or Google Play. OR STEP 3 SET UP Tap the button in the app, choose Light Strips, and select your model. Follow the instructions in the Tapo app to complete the setup. Installation Tips To avoid damaging your light strip, note the following tips. 1. Only cut the exceeded length along the cutting lines of the light strip after unplugging the light strip. STEP 2 CONNECT HARDWARE Connect all the parts. When connecting the light strip to the controller, make sure the arrows point at each other. Button Explanations Control Button · Press once to turn on/off your light strip · Press twice to switch preset lighting effects · Press and hold for 5s, then release to reset only Wi-Fi settings · Press and hold for 10s to restore factory settings 2. Avoid any sharp corners or turns behind the LED beads. 90° LED Install Your Light Strip 1. Choose a location that avoids static and eases away from splashing water. Find a clean, dry and smooth surface, then wipe off the dust. 2. Slowly peel away the 3M adhesive backing and take it out bit by bit. 3. Stick the light strip and press it down for 10-15 seconds. Secure the controller with the adhesive pads. Do not move it to other place after it is attached. 4. Plug in the power adapter to power on your light strip. Safety Notice · NOT FOR EMERGENCY LIGHTING · Not intended for recessed installation in ceilings, or soffits. · Only use the control provided with or specified by these instructions to control this device. · To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. · Use only insulated staples or plastic ties to secure cords. · The maximum distance to the receptacle is determined by the length of adapter cord. · Keep the device away from water, fire, humidity or hot environments. · Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us. · Do not use the device where wireless devices are not allowed. · Do not use damaged charger or USB cable to charge the device. · Do not use any other chargers than those recommended. · Adapter shall be installed near the equipment and shall be easily accessible. · Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall; · Position the portable cabinet light with respect to the cabinet so the lamp replacement markings are able to be read during replacing; · The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted. Support For technical support, the user guide and other information, please visit https://www.tapo.com/support/.Adobe PDF library 10.01