Whirlpool W8I HF58 TU UK Built-In Dishwasher Installation Guide
General Information & Requirements
This guide provides instructions for installing the Whirlpool W8I HF58 TU UK Built-In Dishwasher. Ensure all safety precautions are followed.
Cabinet Preparation:
- Required cabinet dimensions:
- Height: 820-900 mm
- Width: Minimum 560 mm
- Depth: Minimum 600 mm
Dishwasher Unit Specifications:
- Maximum unit height: 760 mm
- Maximum load for top panel: 10 kg
Sound Level: 38/39/40/42 dB ?
Service Information: ?️❓
Required Tools and Accessories:
- Gloves ?
- Screwdrivers (types a, b, c)
- Pliers
- Spirit Level
- Measuring Tape ?
- Pencil
Fasteners and Parts:
- 4x Screws: Ø4x38 mm (part d)
- 2x Screws: Ø4x25 mm (part e)
- 4x Screws: Ø3.5x18 mm (part f)
- Mounting brackets and plates (parts g, h, i)
- Item k (hose/cable)
Step 1: Preparing the Dishwasher Door Panel
Attach the decorative front panel to the dishwasher door. Ensure correct alignment using the indicated measurements (e.g., 598 mm / 594 mm).
Step 1A: Attaching the panel to the dishwasher door.
Step 1C: Inserting a panel into a slot, securing with screws.
Step 2: Attaching Mounting Hardware
Secure necessary mounting brackets and hardware to the dishwasher unit using the provided screws.
Step 2B: Attaching bracket 'e' and screws 'b', 'f' to the dishwasher.
Step 2D: Attaching the dishwasher to the cabinet using screws 'b', 'c', 'd', 'h'.
Step 3: Positioning the Dishwasher
Slide the dishwasher into the prepared cabinet space. Ensure a gap of approximately 14 mm is maintained at the top for panel alignment.
Step 3: Dishwasher positioned under the countertop.
Step 4: Dishwasher installed within the cabinet structure (indicated by dashed lines).
Step 4: Leveling and Securing
Adjust the leveling feet to ensure the dishwasher is stable and level. Secure the dishwasher to the cabinet using the provided screws and brackets.
Step 5: Adjusting leveling feet for stability.
Step 8: Securing the dishwasher to the cabinet using screws 'c' and brackets 'b'. Arrows indicate adjustment points.
Step 5: Attaching the Front Panel
Attach the decorative front panel to the dishwasher door. This step may involve multiple screws and adjustments depending on the panel type.
Step 9a & 9b: Detailed views of attaching the front panel using screws 'b', 'c', 'i' and possibly hinges.
Step 6: Final Checks and Connections
Perform final checks on panel alignment and ensure all connections are secure.
Step 10a: Close-up of panel edge, showing a minimum gap of 5 mm.
Step 10b: Water and electrical connections:
- Water Inlet Pressure: Minimum 0.05 MPa / 0.5 Bar, Maximum 1 Mpa / 10 Bar.
- Minimum water hose diameter: Ø 25 mm.
- Drain Hose Length: Minimum 400 mm, Maximum 800 mm.
- Water Supply Hose Lengths: Approximately 1300 mm, 1500 mm, 1500 mm.
- Electrical connection: Standard power outlet required.
- Prohibitions: Ensure correct connections and placements are followed (indicated by 'X' symbols).
Product Information
Product Code: 400011674897B
Document Version: 08/2023
