Flexson E100WM Wall Mount for Sonos Era 100

Mounting on Masonry

Required Tools: Drill, Pencil, Spirit Level, Screwdriver.

Included Hardware (per wall mount):

• 2 x M4 Plastic expansion screws
• 2 x M4 x 45mm Countersunk Head Self tapping Pozi-drive screws
• 2 x M5 x 12mm Countersunk Head Pozi-drive screws
• 2 x M4 x 18mm Countersunk Head Hex-drive screws

Steps:

1. Position the Bracket: Hold the wall mount bracket against the wall at the desired height. Use a spirit level to ensure it is straight. Mark the screw hole positions with a pencil.
2. Drill Holes: Drill holes at the marked positions. Insert the M4 plastic expansion screws into the drilled holes.
3. Attach Bracket: Align the bracket with the holes and secure it to the wall using the M4 x 45mm countersunk head screws.
4. Attach Speaker Mount: Attach the speaker mounting plate to the wall bracket using the M5 x 12mm countersunk head screws.
5. Mount Speaker: Slide the Sonos Era 100 speaker onto the mounting plate and secure it using the M4 x 18mm countersunk head screws.

Mounting on Wood Studs

Required Tools: Drill, Pencil, Spirit Level, Screwdriver.

Included Hardware (per wall mount):

• 2 x M4 x 45mm Countersunk Head Self tapping Pozi-drive screws
• 2 x M5 x 12mm Countersunk Head Pozi-drive screws
• 2 x M4 x 18mm Countersunk Head Hex-drive screws

Steps:

1. Locate Studs: Use a stud finder to locate wooden studs in the wall. Position the wall mount bracket over a stud at the desired height. Use a spirit level to ensure it is straight. Mark the screw hole positions with a pencil.
2. Attach Bracket: Align the bracket with the marked positions and secure it directly to the wooden stud using the M4 x 45mm countersunk head screws.
3. Attach Speaker Mount: Attach the speaker mounting plate to the wall bracket using the M5 x 12mm countersunk head screws.
4. Mount Speaker: Slide the Sonos Era 100 speaker onto the mounting plate and secure it using the M4 x 18mm countersunk head screws.

Attaching the Speaker to the Mount

Steps:

1. Connect Cables: Ensure all necessary cables (power, audio) are connected to the Sonos Era 100 speaker.
2. Align Speaker: Carefully align the speaker with the mounting plate on the wall bracket.
3. Secure Speaker: Insert and tighten the M4 x 18mm countersunk head screws through the designated holes on the speaker and into the mounting plate.

Note: Ensure all screws are tightened securely but do not overtighten.