EKOLN Toilet Brush
This document provides assembly instructions for the EKOLN toilet brush by IKEA.
General Assembly Guidance
The initial diagrams show general advice for IKEA product assembly. One figure appears contemplative with a question mark [?], suggesting a need for careful attention. Another figure is depicted near an IKEA store, implying that seeking assistance or following instructions precisely is recommended.
Assembly Steps
Step 1: Handle Assembly - Part 1
Take the lower section of the handle, which features a threaded end. Connect this threaded end to the corresponding threaded base of the upper handle section by screwing them together.
Step 2: Handle Assembly - Part 2
Join the two assembled handle sections together. Ensure they are firmly connected. An inset diagram highlights a specific connection detail for proper alignment.
Step 3: Inserting Brush Head
Place the TRONNAN brush head into its holder. Then, carefully insert the assembled handle into the top of the TRONNAN brush head. The handle's threaded end engages with the brush head.
Step 4: Securing the Brush Head
Gently press down on the TRONNAN brush head while aligning the handle with the designated slot or opening within the holder. Push the handle into place to secure it.
Step 5: Final Assembly
The EKOLN toilet brush is now fully assembled, with the handle securely attached to the brush head and holder.
Maintenance and Replacement
Information (i): To clean the toilet brush, remove the TRONNAN brush head from the holder. The old brush head can be disposed of in a waste bin. Replace it with a new TRONNAN brush head as needed.
