AEORC RX34x Series Mini Micro Receiver. (with 2CH electromagnetic
Instruction Manual. Thank you ... matching mode, the receiver starts to search for the signal and perform frequency matching, and the. LED light ...
Instruction Manual Thank you for choosing AEORC ultra-micro receiver, this receiver integrates 5A/1S brushed ESC, with 2CH electromagnetic servo control function, and with 5CH PWM signal output function, please read this document carefully before use.
File Info : application/pdf, 2 Pages, 408.71KB
DocumentDocumentAEORC RX34x Series Mini Micro Receiver (with 2CH electromagnetic servo control function) Instruction Manual Thank you for choosing AEORC ultra-micro receiver, this receiver integrates 5A/1S brushed ESC, with 2CH electromagnetic servo control function, and with 5CH PWM signal output function, please read this document carefully before use. Version selection For RX34x series, now we have below 8 versions for choice, please understand the corresponding basic functions according to the product you purchased. RX342 RX344 RX345 Protocol S-FHSS DSMX/2 FRSKY-D16 5A/1S Brushed ESC 2CH electromagnetic servo control TELEM RX346 FlyskyAFHDA-2A RX347 FRSKY-D8 RX344-T DSMX/2 RX345-T FRSKY-D16 RX346-T FlyskyAFHDA-2A Basic Data Size 16*10*2.5mm Weight 0.5g Working voltage3.0-4.2V Built-in 2CH electromagnetic servo driver (512 class resolution) Interface Definition Combine receiver and transmitter AEORC RX34x Series Mini Micro Receiver (with 2CH electromagnetic servo control function) Instruction Manual 1.Turn on the transmitter and power the receiver. At this time, the receiver is in the state of confirming the transmitter signal, and the LED light flashes slowly. 2.If the transmitter signal cannot be confirmed within 15 seconds, then enter the automatic frequency matching mode, the receiver starts to search for the signal and perform frequency matching, and the LED light flashes quickly. 3.If the frequency matching is successful, according to different types of remote transmitters , there will be a variety of different LED light feedbacks, including but not limited to the following three LED light flashing methods. Please confirm according to the actual remote control whether the frequency matching is successful or not. How to use ESC Connect the positive pole of the brushed motor to"M+" and the negative pole to "M-"to replace the throttle channel, as picture 1.1. The integrated brushed ESC has the lock function of preventing accidental touch. After the receiver is powered on, the throttle channel remains at the lowest position for more than 2 seconds, then this function can be canceled and the brushed ESC can be used normally. Connection for 2CH electromagnetic servo and PWM signal servo Electromagnetic servo connection: Connect the positive pole to"CH1 Magnet Servo 1" and the negative pole to "CH2 Magnet Servo 2", and set up the servo's positive inversion with transmitter. Then you can control the electromagnetic servo after combining transmitter. PWM signal servo connection: The most frequently used servo is PWM mode, so please confirm the voltage range of servos. Connect the negative/positive/signal (black/red/white) three wires to GND/ VIN / CH1-CH6"respectively, then you can control the servo after combining. TELEM Function Introduction Firstly , you need a remote control with TELEM to use this TELEM function. This function could realize real-time monitoring to battery voltage, receiver voltage, receiver signal strength and receiver operating temperature, allowing users to master the working status of receiver and battery in real time to avoid unexpected situations in flight.Adobe PDF library 15.00 Adobe Illustrator CC 22.1 (Windows)