MUSE M-35 BT Portable Radio CD/MP3 Player with Bluetooth and USB

Location and Description of Controls

1. FM telescopic antenna
2. Carrying handle
3. CD Compartment
4. : USB port for MP3 playback
5. SOURCE: To turn unit on/off; To select between Aux, FM, CD, USB or Bluetooth mode.
6. : Play/ Pause; Disconnect the paired Bluetooth device; Auto preset radio stations
7. VOLUME : Volume up/ down
8. / P+: Skip/ Search; Preset recall
9. / 1: Skip/ Search; Quick preset button 1
10. FOLDER / 2: Folder down; Quick preset button 2
11. FOLDER / 3: Folder up; Quick preset button 3
12. PROG. / 4: To program playback sequences; Quick preset button 4
13. REPEAT / 5: Repeat & random playback; Quick preset button 5
14. TUNING : Tuning knob
15. LCD display
16. : Preset radio stations; To stop playback
17. SLEEP : To fall asleep with the radio
18. : Phones jack
19. AUX IN jack (3.5MM)
20. Speakers
21. AC socket
22. Battery Compartment

Power Supply

This set operates on AC 230V 50Hz or 6 x 1.5V R14/ UM-2/ “C” size batteries (not provided).

AC Operation

Connect the detachable AC cord (included) to the AC socket on the rear of the unit. Insert the AC power cord into a convenient standard AC wall outlet.

DC Operation

Install the batteries in their compartment. Use only the size and type of batteries specified. Respect the polarity indicated in the compartment. Improper polarity can cause damage to the device.

• Do not attempt to recharge the batteries; they can catch fire or explode.
• Batteries need to be replaced when the volume decreases or sound is distorted.
• To avoid leakage, remove batteries if the unit will not be used for a long period.
• When battery power is low, the "?" indicator will blink on the display.

Caution: Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.

Note: The AC cord must be unplugged from both the unit and the power outlet for the unit to run on batteries. When connected to mains, power source automatically switches to AC. For energy saving, the unit will automatically turn off after 15 minutes of inactivity.

Operating the Unit

Turning Unit On/Off

Press and hold the SOURCE button to turn the unit on. Press and hold the SOURCE button again to turn it off.

Selecting Source/Mode

When the unit is ON, press the SOURCE button repeatedly to select between Aux, FM, CD, USB, or Bluetooth mode.

Listening to the Radio (FM)

When the unit is ON, press the SOURCE button repeatedly to select FM mode. The "?" indicator will appear on the display.

Manual Search

1. Tune to your desired station using the TUNING knob.
2. Adjust the volume to your desired level.

Automatic Search

Quickly rotate the TUNING knob to locate strong stations. For weaker signals, rotate the TUNING knob slowly. Note: Sound is muted during search.

To improve reception, extend the telescopic antenna and adjust its position.

Preset Stations

This unit can store up to 20 FM stations.

1. Tune to a desired station using the TUNING knob.
2. Press the " " button once. "P01" will blink on the display.
3. Press P+ repeatedly or rotate the TUNING knob to select a preset number (1-20).
4. Press the " " button again to store the station.
5. Repeat steps 1-4 for other stations.

Quick Presets: Use the 1, 2, 3, 4, 5 buttons to store and recall stations quickly.

Auto Preset

Press and hold the " " button to start automatic programming. The unit will scan frequencies and store available stations. It stops when all stations are stored or memory is full.

Listening to Preset Stations

Press P+ repeatedly to cycle through preset stations. Alternatively, press the quick preset buttons (1-5) to recall stored stations.

Listening to a CD

1. When the unit is ON, press SOURCE repeatedly to select CD mode. The "?" indicator will appear.
2. Open the CD door.
3. Insert a CD with the label facing up, then close the door.
4. After a few seconds, the total number of tracks will display, and playback will start automatically.

Notes: If the disc is MP3, "MP3" will be displayed. If the disc is dirty, damaged, or inserted incorrectly, "No Cd" will appear. Clean or try another disc.

Playback Controls

• Play/Pause (▶️/⏸️): Press to pause, press again to resume.
• Stop (⏹️): Press to stop playback.
• Skip/Search (⏭️ / ⏪): Press to skip tracks. Press and hold to fast scan within a track.
• Repeat/Random (?): Press to cycle through Track Repeat, Repeat All, Random Play, Repeat Folder (MP3/USB only). Press again to cancel.
• Program (PROG.): Allows programming a sequence of up to 20 tracks (CD) or 99 tracks (MP3). Press PROG. to enter programming mode, use / to select tracks, and PROG. to confirm. Press to start programmed playback. Press twice to cancel.

Select a Folder (MP3 Only)

Use the FOLDER / buttons to navigate between folders on MP3 discs or USB devices.

Troubleshooting CD Playback

1. Turn off the unit, unplug it, and plug it back in.
2. Clean the CD.

USB Playback

1. Connect a USB device to the USB port.
2. When the unit is ON, press SOURCE repeatedly to select USB mode. The "?" indicator will appear.
3. Playback starts automatically after a few seconds, showing the total number of folders and tracks.

Notes: Max 999 MP3 files, max 99 directories. Reading time varies. Do not insert anything other than USB devices. Do not connect USB port directly to a computer.

Bluetooth Function

The Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc.

Pairing a Bluetooth Device

1. When the unit is ON, press SOURCE repeatedly to select Bluetooth mode. The "?" indicator will blink slowly.
2. On your Bluetooth device, enable Bluetooth and select "MUSE M-35 BT". Use "0000" if a passcode is required. You will hear an indication sound upon successful pairing. The "?" indicator will stop blinking.

Tip: To connect to a different device, press and hold the " " button to disconnect the current device, then repeat pairing.

• For computers, select the unit as an "Audio Device (stereo)".
• Pairing remains active even if devices go out of range; connection will re-establish when back in range.
• The unit will attempt to reconnect to the last paired device upon power-on.

Compliance: NEW ONE S.A.S declares that this MUSE M-35 BT complies with Directive 2014/53/EU. Declaration of conformity available at www.muse-europe.com.

Using a Bluetooth Device

1. Operate your Bluetooth device; sound will play through the M-35 BT.
2. Press " " to pause, press again to resume.
3. Select tracks using / .
4. Adjust volume with the VOLUME knob or on your paired device.

Note: The Bluetooth indicator stops blinking during playback.

Connecting Auxiliary Source

1. Connect your auxiliary source (e.g., MP3 player) to the AUX IN jack (cable not included).
2. When the unit is ON, press SOURCE repeatedly to select AUX mode. The "➕" indicator will appear.
3. Start playback from your auxiliary source.
4. Adjust volume.
5. To stop, disconnect the auxiliary source.

Using Headphones / Earphones

Maximum output voltage: ≤ 150 mV

Headphone Volume Warning

Connect headphones with the volume low, then increase as needed. Prolonged listening at high volumes can cause hearing damage. When headphones are connected, the unit's speakers are deactivated.

Caution: Avoid listening at levels harmful to your ears.

Sleep Function

Press the SLEEP button repeatedly to select sleep timer duration (15, 30, 60, 90, 120 minutes). The "?" indicator lights up. The unit will turn off automatically. To cancel, press SLEEP until "OFF" is displayed and the indicator turns off.

Maintenance

Cleaning

Warning: Disconnect from power before cleaning.

• Use a soft, dry, clean cloth. Dust vents regularly.
• Avoid solvents or abrasive/alcohol-based cleaners.
• If an object or liquid enters the unit, unplug immediately and have it checked by an authorized technician.

Notes on Discs

• Do not use irregularly shaped CDs.
• Do not place more than one disc in the compartment.
• Do not open the CD compartment during playback.
• Do not touch the lens.
• Clean discs if scratched, dirty, or smudged. Wipe from center outwards.
• Store discs away from high temperatures and humidity to prevent warping.
• Replace discs in their cases after playing.

Important Note: Remove the disc before transporting the unit.

Technical Specifications

Power Supply:

AC: 230V 50Hz, 18W consumption

DC: 6 x 1.5V, R14/UM-2/"C" size batteries (not provided)

Radio:

FM: 87.5-108 MHz

CD Player Section:

Frequency Response: 100Hz - 20kHz

Signal-to-Noise Ratio: 40 dB

Aux In Section:

3.5mm AUX jack

Bluetooth:

Bluetooth: 2.402-2.48GHz

RF Output Power: +6 dBm

Bluetooth Version: V5.3

Working Distance: Up to 10 meters (open space)

Specifications are subject to change without notice.

Important Safety Instructions

• Caution: To reduce the risk of electric shock, do not disassemble. Refer servicing to qualified technicians.
• Warning: To prevent fire or shock hazard, do not expose to rain or moisture.
• Laser Product: This unit is classified as a Class 1 Laser product. Avoid exposure to laser beam.
• General Safety: Use in moderate climates. Ensure 5cm ventilation space. Do not place near heat sources or liquids. Dispose of batteries responsibly. Keep power plug accessible. Reset device if it malfunctions due to electrical phenomena or EMI.
• Disposal: Recycle electrical products according to local regulations.