Installation Instructions for Ceiling Mounted Electric Flip TV Stand

Step 1: Prepare Main Body

Connect the main body of the bracket to the power supply and adjust it to the open state. Use a screwdriver [screwdriver] to unscrew the four fixing screws on the inner side, and remove the front connecting hanging plate for standby.

Step 2: Mount Support Wallboard

Place the support wallboard to be installed, mark the hole position and punch holes. Insert the expansion pipe into the hole, and fix the support body through the wallboard with the expansion screw.

Installation Tips:

The expansion screws corresponding to the left and right hoist holes can be screwed into the expansion plugs for about 1/2. Then, the main body of the bracket is sheathed with the expansion screw cap through the large hole of the hoist hole. Next, the bracket is translated to the hollow hole of the hoist for temporary suspension. Finally, install the expansion screws at the other four positions, and then fix all expansion screws. This method makes installation more labor-saving.

Step 3: Install Trellis

Thread the two beams into the two holes on the upper and lower sides of the hook respectively. Install the plugs at both ends of the beam and fix them with screws. Connect the upper and lower four holes of the connecting clevis with the four holes in the middle of the beam using bolts and nuts.

Step 4: Connect TV to Frame

Select two vertical hooks of the well frame to fit the hole position, and connect the well frame to the hole position on the back of the TV. Install the upper and lower safety screws of the two hooks respectively.

Step 5: Attach TV to Main Body

As shown in the figure, connect and fix the four hole positions of the connecting hanging board with the TV. Ensure the TV is well connected to the hole positions of the front end of the main body using the spare screws removed in step 1.

Remote Controller

• Automatic flip down
• Stop
• Automatic flip up

Handset

• Extend
• Retract