Introduction
Thank you for purchasing our product. Before use, please read these instructions carefully.
Site Preparation
Kit before you begin / Site preparation
- Before beginning construction, check local building codes regarding footings, location and other requirements.
- Follow all directions and dimensions carefully.
- Follow the step sequence carefully for correct results.
- Be sure all the parts fit together properly before proceeding.
- SAFETY FIRST: Care must be taken when handling various pieces of your kit because some contain sharp edges. Wear work gloves, eye protection and long sleeves when assembling or performing any maintenance on your kit.
- BASIC TOOLS: Screwdriver, pliers, work gloves, tape measure, level and a spade or shovel.
- GROUND MUST BE LEVEL: Be sure floor frames lie flat on ground. To prepare construction, remove sods and other bumps. Level the high spots with flat shovel and tamp down the construction.
- Separate contents of the carton according to the part number while reviewing parts list. Check to be sure that you have all the necessary parts for your kit.
Parts List
| Part ID | Dimensions | Quantity |
|---|---|---|
| V-A1 | 1024 mm | 8x |
| V-A4 | 1663 mm | 6x |
| V-A5 | 969 mm | 4x |
| ST4x10 mm | 32x |
A visual representation of the parts and their quantities is provided in the original document.
Installation Guide
Step 1
Attach three V-A4 components together using screws. A close-up view shows screws inserted into pre-drilled holes.
Step 2
Assemble the main frame by connecting V-A1 and V-A4 components. Two methods (I and II) are shown for connecting these parts. The main diagram illustrates multiple connections forming a grid. This step involves repeating sub-assembly I eight times and sub-assembly II four times.
Step 3
Connect V-A1 and V-A5 components to the assembled frame to create additional support structures.
Step 4
Secure the structure by attaching V-A4 components and connectors (Bs-G3, Bs-G3a). Sub-step I indicates the need to drill a small hole. The main diagram shows multiple points for these attachments.
Assembly Guidance
Correct vs. Incorrect Assembly
Ensure parts fit together correctly and are aligned flush. Incorrect assembly can lead to structural issues.
Correct Assembly: Diagrams show parts fitting flush and aligned properly.
Incorrect Assembly: Diagrams illustrate misaligned or improperly fitted parts.
Notes
Images used in this manual are for illustrative purposes only and may differ from the actual product.
