HEADRUSH HRSP3037 WAVE II Wireless Waterproof Floating Speaker

Instruction Manual

What's Included:

  • Speaker with strap
  • Micro USB charging cable
  • 3.5mm audio cable
  • Instruction Manual

Product Overview

The HEADRUSH HRSP3037 WAVE II is a wireless, waterproof, floating speaker designed for streaming music and hands-free calling via Bluetooth®. It features an IPX7 rating, meaning it is protected against short-term immersion in water.

Component Identification

  1. Power ON/OFF button
  2. LED indicator
  3. Microphone
  4. Play/Pause/Answer button (▶||)
  5. Decrease volume/Previous track button (-)
  6. Increase volume/Next track button (+)
  7. AUX input port
  8. Charging LED indicator
  9. Micro USB charging port

Operation

ActionTo Do
Play/PausePress the button to pause, press again to play.
Next trackPress and hold the + button for 2 seconds.
Previous trackPress and hold the - button for 2 seconds.
Increase volumePress the + button.
Decrease volumePress the - button.
Answer callPress the button.
End callPress the button.

Handsfree Speakerphone

When a smartphone is connected:

  1. Press the Play/Pause button to answer an incoming call.
  2. Press the Play/Pause button again to end the call.

Line-in (AUX In) Mode

  1. Use the supplied 3.5mm audio cable to connect the speaker directly to your device.
  2. The white LED indicator will turn ON.

Tip: LINE-IN mode takes priority over the Bluetooth® connection.

Understanding the LED Status Lights

  • When charging your speaker: Red LED indicates charging. Red LED OFF indicates charging is complete.
  • When pairing your speaker to a Bluetooth® device: Quick-blinking white LED indicates Bluetooth® is not connected and ready to pair. Slow-flashing white LED indicates Bluetooth® is connected.
  • When connected via LINE-IN: White LED is ON.

Technical Specifications

  • Bluetooth® Version: Bluetooth® 5.0
  • Battery Capacity: 3.7V, 2000mAh
  • Frequency Response: 80Hz-20kHz
  • Operation Distance: Up to 10 metres/33 feet
  • TWS Distance: 3.5 metres/11.5 feet
  • Output Power: 5W x 2 (Max)

Note: This speaker is in compliance with the specified Bluetooth® version. Compatibility with all functions on every Bluetooth® enabled device is not guaranteed. Please check your mobile phone's user manual for compatibility and functionality.

Charging

Use the included Micro USB charging cable to fully charge the speaker before first use. Charging takes approximately 3.5 hours.

  • The red LED indicator is ON while charging.
  • The red LED indicator turns OFF when charging is complete.

Tip: When the battery is low, the speaker will flash every five seconds. Please charge the speaker. If not plugged in to charge within approximately 15 minutes, the speaker will automatically turn OFF.

Pairing

  1. Press and hold the power button to turn the speaker ON. The white LED indicator will flash quickly, and the speaker will chime.
  2. Enable Bluetooth® on your device and select "HRSP 3037".
  3. Once paired successfully, the white LED indicator will flash every five seconds, and the speaker will beep.
  4. If pairing fails or you wish to pair with a new device, repeat the above steps.

Note: During pairing mode, the white LED indicator flashes. If no device is paired or the speaker remains inactive for 30 minutes, it will turn OFF. To un-pair, disconnect from your device's Bluetooth® settings.

Note: The speaker will automatically re-pair with previously connected devices if Bluetooth® is ON and within range. The speaker will chime to indicate successful re-pairing.

TWS (True Wireless Stereo) Connection

Connect two HEADRUSH WAVE II speakers for a true wireless stereo experience.

  1. Ensure neither speaker is connected to your device via Bluetooth®, and turn Bluetooth® OFF on your device.
  2. Press and hold the power button on both speakers to turn them ON.
  3. Quickly press the power button twice on *both* speakers to enter TWS mode. The main speaker will beep once when paired to the other speaker (approximately 10 seconds). The white LED on the main speaker will flash, and the white LED on the second speaker will be ON.
  4. Turn Bluetooth® ON on your device and select "HRSP 3037".
  5. Press and hold the power button on both speakers to turn them OFF.

Note: The two speakers will automatically pair to each other each time they are turned ON. To unpair them, quickly press the power button twice on each speaker. The main speaker will beep, and the white LEDs will flash briefly, indicating they are no longer paired.

Troubleshooting

No Sound:

  • Ensure the speaker is charged and has sufficient battery power for operation.
  • Ensure the speaker is switched ON.
  • Ensure your Bluetooth® device is ON.
  • Adjust the speaker volume to an appropriate level.

Note: If the speaker beeps every few seconds, the battery is low. Please recharge the speaker.

Important Safety Information & Warnings

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Please avoid salt water or chlorinated pools to prevent corrosion.

Regulatory Information

RSS 247

This device contains licence-exempt transmitter/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

IC: 255A-8086937

The Source - Warranty

The Source warrants that this product will be free from defects in materials and workmanship for a period of 12 months from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer, and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.

This warranty is only applicable to a product purchased through The Source company-owned stores or participating dealers in Canada where the warranty is included with the product. While this warranty does not confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other governmental entities in which The Source operates. This warranty is subject to all statutory rights you may have in Canada.

Imported by: The Source, Barrie, Ontario, Canada, L4M 4W5

Manufactured in China

www.thesource.ca

© 2020 The Source. All rights reserved.

Please Recycle ♻️

Models: Wireless, Waterproof, Floating, Speaker, HRSP3037, Wave II, HEADRUSH

PDF preview unavailable. Download the PDF instead.

108086939 Manual Adobe PDF Library 15.0 Adobe InDesign 15.0 (Windows)

Related Documents

PreviewHEADRUSH HRSP 5038 MINI RAVE Wireless Speaker Instruction Manual
Comprehensive instruction manual for the HEADRUSH HRSP 5038 MINI RAVE wireless speaker. Learn how to pair, connect via Bluetooth or AUX, use TWS mode, and troubleshoot common issues.
PreviewHeadrush HRSP 5042 Wireless Speaker User Manual
User manual for the Headrush HRSP 5042 wireless speaker, covering Bluetooth pairing, TWS connection, hands-free calling, operation, charging, and troubleshooting.
PreviewHeadrush Portable Bluetooth Speaker User Guide
This user guide provides instructions for the Headrush Portable Bluetooth Speaker (model 8004081/82), covering setup, pairing, charging, operation, and safety information. Learn how to connect wirelessly to Bluetooth-enabled devices, manage calls, and troubleshoot common issues.
PreviewHEADRUSH HRSP 5044 Wireless Speaker: User Manual and Features
Comprehensive guide to the HEADRUSH HRSP 5044 Wireless Speaker, covering setup, operation, Bluetooth pairing, TWS connection, karaoke, troubleshooting, and technical specifications.
PreviewHeadrush Urban - Mini Portable Bluetooth Speaker with NFC - Model 8062738
Explore the Headrush Urban - Mini, a compact portable Bluetooth speaker featuring NFC technology, 5W RMS output, and a 1300mAh battery. Includes technical specifications, dimensions, and control button descriptions.
PreviewHeadrush FRFR-112 MK2 Quickstart Guide: Setup and Component Identification
Get started quickly with the Headrush FRFR-112 MK2 powered speaker. This guide provides essential setup information and component identification.
PreviewHeadRush FRFR-108 MK2 User Guide
Comprehensive user guide for the HeadRush FRFR-108 MK2 powered speaker, covering setup, features, operation, troubleshooting, and technical specifications. Learn how to connect, configure, and use your FRFR-108 MK2 for optimal audio performance.
PreviewHeadRush VIBE Wireless Speaker Instruction Manual
Instruction manual for the HeadRush VIBE Wireless Speaker (Model HRSP 5040), covering product overview, operation, TWS connection, charging, pairing, hands-free speakerphone, line-in mode, technical specifications, and troubleshooting.