Forward and Reverse Remote Control Switch
Specifications
- Working voltage: DC3V (23032 battery)
- Working current: ≤8MA
- Working temperature: -20 - +65℃
- Modulation method: ASK
- Operating frequency: 433.925MHZ
- Transmission rate: 2Kbit/s
- Transmit power: <1.mw
Remote Control Operation
Instantaneous Mode
Press the upper button of the remote control, the motor will turn forward, and then the motor will stop after release. Press the lower button of the remote control, and the motor will reverse, and the motor will stop after release.
Lock Mode
Press the up button of the remote control once, the motor will turn forward. Press the stop button of the remote control again, the motor will stop. Press the down button of the remote control once, the motor will reverse. Press the stop button of the remote control again, the motor will stop.
Remote Control Pairing Method
Click Pairing
Click: Press the study button on the controller once, and the study indicator will flash once and then turn on. Press the remote control button of "[Up Arrow]" again, and the study indicator will flash on three times. Please press the "[Down Arrow]" button again, and the study indicator will flash on three times and then turn off.
Interlock Pairing
Interlock: Continuous, key secondary controller learning study lamp with flash light. After the second "[Up Arrow]" a learning remote control button, indicator flashes three times on learning. "[Square]" please press again the remote control key, learning after the indicator light flashes three times again bright. Again please click "[Down Arrow]" key, lights flashing three times after learning, learning success.
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The device has evaluated to meet general RF exposure requirement. The device can be used be in portable exposure without restriction.