Babelio Safety Gate

Before Installation

Warning: Please do not cut the zip tie until you finish installation, preventing the gate from swinging back and forth.

Diagram Description: The gate is shown secured with a zip tie. An instruction indicates that the zip tie should not be cut until installation is complete to prevent the gate from swinging.

Installation Location

Bottom of Stairs

If the gate is used at the bottom of the stairs, it must be placed on the lowest stair to prevent children from climbing upstairs.

Diagram Description: Illustrates the gate positioned on the lowest stair step.

Top of Stairs

If the gate is used at the top of the stairs, it must be placed 15cm (6 inches) back from the top step to prevent children from falling down the stairs.

Diagram Description: Shows the gate positioned 15cm (6 inches) back from the top step, with indications of the landing and floor.

Warning: NEVER use the gate on stairs without wall cups or other mounting hardware.

Doorway & Opening

Warning: Install the gate as close to the ground as possible.

Diagram Description: Front, top, and side views of a doorway are shown, illustrating the gate's placement relative to walls and the floor. A 90-degree angle is noted in the top view.

Pressure-Mounted Installation

1. Use a tape measure to figure out the opening width.

   Diagram Description: A tape measure is depicted measuring an opening width.

2. Insert 4 bolts respectively.

   Diagram Description: Four bolts are shown being inserted into the gate frame.

3. IMPORTANT: Check locations A and B. The distance between the gate and the wall should never exceed 2.75 inches (approximately 7 cm).

   Diagram Description: Two points (A and B) on the wall are highlighted, indicating the mounting locations. The maximum allowed distance between the gate and the wall is specified as 2.75 inches.

4. Rotate 4 bolts to tighten all bolts inward.

   Diagram Description: Bolts are shown being rotated to secure the gate against the wall. The zip tie is shown being cut.

Hardware-Mounted Installation

Diagram Description: The gate is shown being opened.

Warning: NEVER install three extension frames on the same side of the gate.

Using Gate Extensions

Secure gate extensions with reinforcement groove.

Diagram Description: Diagrams show how gate extension frames attach to the main gate and are secured using a reinforcement groove.

Using the Y-Spindle Rod

Secure the gate to round baluster with Y-spindle rods.

For stairs with round baluster or baluster with diameter less than 1.2 inches, install the safety gate with the Y-spindle rod.

Diagram Description: Diagrams illustrate the use of Y-spindle rods to attach the safety gate to round balusters, specifically for those with a diameter less than 1.2 inches.

Notes

1. The gap between the gate latch and the frame is NOT a defect. This gap will be eliminated after installation.
2. If you cut off the zip tie before installation, you can still install the safety gate normally.

Important Safety Warnings

Warning: You MUST install wall cups to keep the gate in place. Without wall cups, a child can push out and escape.

Warning: Children have died or been seriously injured when gates are not securely installed.

• ALWAYS install and use the gate as directed using all required parts.
• Install according to manufacturer's instructions.
• STOP using when a child can climb over or dislodge the gate.
• Use only with the locking/latching mechanism securely engaged.
• NEVER use a gate to keep a child away from a pool.
• NEVER leave a child unattended.
• TO prevent falls, never use at the top of stairs without wall mounting cups and a door stopper.
• Always close and lock the gate behind you.
• This product will not necessarily prevent all accidents.
• Do not use if any components are missing or damaged.
• Intended for use with children from 6 months to 24 months.
• Adult assembly required.
• Exercise care when unpacking and assembling the product.
• Install with this side AWAY from the child.