1. Parts and Components
The coffee machine consists of the following parts:
- 1. Pressure gauge
- 2. Hot water tube
- 3. Cup-holder tray
- 4. Drip tray
- 5. Water tank cover
- 6. Water tank
- 7. Steam knob
- 8. Steam tube
- 9. Double espresso filter
- 10. Espresso filter
- 11. Portafilter and filler funnel
- 12. Coffee press
- 13. Full-tray indicator
Diagram Description: An exploded view of the coffee machine shows its main body, top cover, water tank, drip tray, cup-holder tray, and various filter components (double espresso filter, espresso filter, portafilter, coffee press) laid out separately, with numbered labels indicating each part.
Machine Controls
The control panel features the following buttons:
- 1. On/off
- 2. Hot water
- 3. Single coffee
- 4. Espresso/2 espressos
Note: Each button has a light indicator ? around it that turns on when the function is activated.
Diagram Description: A top-down view of the control panel shows four buttons labeled 1, 2, 3, and 4, with corresponding indicator lights. These buttons are associated with functions like On/off, Hot water, Single coffee, and Espresso/2 espressos.
2. Safety Instructions
Read these instructions thoroughly before using the appliance. Keep this manual for future reference.
- Follow all safety instructions closely.
- Ensure mains voltage matches the appliance's rating label and the outlet is grounded.
- Do not immerse the cord, plug, or any non-removable part in water or other liquid. Keep electrical connections dry. Ensure hands are dry before handling the plug or switching on.
- Turn off and unplug the appliance from the mains supply when not in use, before cleaning, and before attaching components. Pull the plug, not the cord, to disconnect.
- Do not use the appliance if its cord, plug, or housing is damaged, or if it malfunctions, has been dropped, or damaged.
- Do not attempt to repair the appliance yourself. Contact Cecotec Technical Support Service for advice.
- Do not use accessories not recommended by Cecotec, as they may cause injury or damage.
- Place the appliance on a dry, stable, heat-resistant surface.
- Do not use the appliance under the following circumstances:
- On or near a gas or electric hob, in heated ovens, or near open flames.
- On soft surfaces (like carpets) or where it may tip over.
- Outdoors or in areas with high humidity levels.
- Do not cover the appliance while in use.
- This appliance is intended for domestic use only, not for commercial or industrial use.
- Accessible surfaces may be hot during use and could cause burns. Do not touch hot surfaces. Use handles or knobs.
- Do not operate the device without water.
- Do not leave the appliance unattended while in use. Unplug it when finished or when leaving the room.
- Cleaning and maintenance must be carried out according to this manual. Turn off and unplug before moving or cleaning.
- Cleaning and maintenance tasks must not be carried out by children.
- The appliance is not intended for use by children under 12. Children aged 12 and over can use it with continuous supervision.
- Persons with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge, should only use the appliance if supervised or instructed by a responsible person, understanding the hazards involved.
- Supervise young children to ensure they do not play with the appliance. Close supervision is necessary when the appliance is used by or near children.
Warning: Do not remove the water tank or portafilter when preparing coffee, hot water, or frothing milk to prevent scalding. Before removing the portafilter to brew another coffee, ensure the machine is in standby mode. To add more water, press the power button and wait for indicator lights to turn off.
This product underwent quality control. It may contain residual water drops or coffee.
3. Before Use
- Remove all packaging material, stickers, or labels from the product.
- Ensure all components are included. If not, contact Cecotec Technical Support Service.
- Fill the water tank with water.
- Insert the portafilter into place and turn it anticlockwise to lock it tightly.
- Place a container on the cup-holder tray and connect the machine to a power supply. Ensure the steam knob is set to the off position [position 0].
- Press the power button. The coffee machine will start preheating and then enter standby mode.
- Press the hot water button to dispense hot water and press again to stop. Then, press the espresso or double espresso button to clean the tubing system.
- Use warm water to clean all coffee machine parts.
4. Operation
Preheating
Press the power button. The coffee machine will start preheating while the [on/off indicator] light blinks.
Standby
Once preheated, the device enters standby mode, and the [on/off indicator] light turns steady.
Hot Water
From standby mode, press the [hot water button] to activate this function. The light indicator will turn on while dispensing hot water. The machine dispenses approx. 240 ml hot water and stops automatically, but can be stopped manually by pressing the [hot water button] again. It returns to standby mode afterward.
Espresso
Place an espresso filter in the portafilter, add 13-15 g of coffee powder, and press it down. Align the portafilter with the portafilter bracket, insert, and turn anticlockwise to lock. Place a cup on the cup-holder tray. From standby mode, press the [single-coffee button]. The light indicator will blink, and the machine will start brewing. The [pressure gauge] will display pressure parameters during brewing and reset upon completion. The function finishes automatically or can be stopped manually by pressing the same button.
Double Espresso
Place a double espresso filter in the portafilter, add 20-22 g of coffee powder, and press it down. Align the portafilter with the portafilter bracket, insert, and turn anticlockwise to lock. Place 1 cup for a double espresso or 2 cups for 2 espressos on the cup-holder tray. From standby mode, press the [double-coffee button]. The light indicator will blink, and the machine will start brewing. The [pressure gauge] will display pressure parameters during brewing and reset upon completion. The function finishes automatically or can be stopped manually by pressing the same button.
Recommendation: Preheat the appliance, portafilter, filter, and cup before brewing to ensure optimal coffee taste.
Steam (Milk Froth)
- Turn the [steam knob] to the preheating position. The [on/off indicator] light will turn steady, and the [steam indicator] light will blink. The [steam indicator] light turns steady when the steam function is ready.
- From standby mode, turn the [steam knob] from [position 0] to [position Max]. The [steam tube] will start emitting steam, and the [steam indicator] will blink. Turn the [steam knob] back to [position 0] to turn the function off.
Recommendation: Allow the coffee machine to rest for 1 minute after 10 minutes of continuous steam operation to prevent overheating.
Coffee Customization
Press and hold the single and double espresso buttons simultaneously to enter coffee customization mode. The single and double espresso light indicators will blink.
Press the [espresso button] to dispense an espresso; the light indicator will blink. Press the button again when the desired amount is reached. This amount will be saved.
Repeat for the double espresso button to save the desired amount for a double espresso.
Note: To reset factory settings for coffee amounts, press and hold the corresponding coffee button for 5 seconds until the light indicator flashes twice.
Recommendation: The suggested amount of water for coffees is 20-60 ml for an espresso and 60-100 ml for a double espresso.
Sleep Mode
The coffee machine automatically enters sleep mode after 30 minutes of inactivity. The [on/off button] remains on. Press any button to exit sleep mode.
Coffee Selection
Use freshly ground, deep-roasted coffee specifically for espresso machines. Pre-ground coffee powder remains scented for 7-8 days if stored in a sealed container in a cool place. Do not store coffee in the refrigerator or freezer. Grind coffee beans just before use for best fragrance, which can be maintained for 4 weeks in a sealed container.
For grinding yourself, coffee must be finely ground, resembling salt. If too fine (like flour), it may cause intermittent flow or blockages. If too thick, water flows too fast, reducing flavor. Use a high-quality coffee grinder for uniform, consistent coffee.
Warnings:
- Single or double espressos can only be brewed after preheating.
- The machine will beep and its light indicators will turn on when the water tank is low. Refill the tank to return to normal.
- After using steam, hot water, or brewing functions, the machine may need to cool down before these functions can be used again. Wait until it enters standby mode.
- Empty the drip tray when the [full-tray indicator] rises.
5. Cleaning and Maintenance
- Disconnect the device from the power supply and allow it to cool completely before cleaning.
- Do not use abrasive cleaners or scouring pads.
- Use a soft, dampened cloth to clean the outer part of the device.
- Do not immerse the main body in water or other liquids.
- Wash the water tank, drip tray, and cup-holder tray regularly.
- After using the steam function, clean the [steam tube] immediately with a cloth. Allow steam to escape to prevent blockages. If clogged, use a needle to unblock the tube.
- Turn the portafilter clockwise to detach it. Empty coffee residues and clean with water and a cloth. Do not wash in the dishwasher.
- Clean all parts with water and dry thoroughly before storing or using again.
Cleaning Mineral Deposits
Mineral deposits can affect machine performance. Regular cleaning is important. The frequency depends on water quality and usage.
An Autocleaning cycle is recommended after every 1000 uses. The machine will signal this with a reminder when turned on and indicator lights blinking red twice.
- Fill the water tank with water and descaling product up to the [MAX mark]. Citrus can also be used. (Water and descaling proportion: 4:1).
- Press the [on/off button]. The machine will start preheating, and the indicator light will turn steady.
- Insert the portafilter in its position and ensure it is securely fitted.
- Place a large container (approx. 2 L) on the cup-holder tray, large enough to catch water from the water tube, nozzle, and steam tube.
- Press and hold the [hot water button] for 5 seconds to enter Autocleaning mode.
- Turn the [steam knob] to the [position Max]. Hot water with descaling product will be emitted through the portafilter spouts and hot water/steam tubes. This process takes 10-15 minutes, then the machine turns off.
- Once finished, fill the water tank with clear water and repeat these steps until no descaling product remains.
- Clean the water tank and the drip tray.
Notes: During Autocleaning, the pump turns on/off intermittently (normal). The [steam knob] must not be at [position 0]; the machine will beep to remind you to turn it to [position Max] to clean the steam tube.
6. Troubleshooting
| PROBLEM | CAUSE | SOLUTION |
|---|---|---|
| Water leaks from the bottom of coffee maker. | There is too much water in the drip tray. | Empty and clean the drip tray. |
| The coffee maker is damaged. | Contact the official Technical Support Service of Cecotec. | |
| Water leaks from the portafilter holder. | There is some coffee powder on filter edge. | Clean the filter and portafilter holder. |
| Water leaks from the portafilter holder. | There is some coffee powder on filter edge. | Clean the filter and portafilter holder. |
| Coffee tastes like acid/vinegar. | The device has not been cleaned properly after descaling. | Follow the cleaning and maintenance instructions to clean the device properly. |
| Coffee powder has not been stored in an adequate place and has turned bad. | Use fresh coffee powder, or store unused coffee powder in a cool, dry place. After opening a package, reseal it tightly. | |
| The coffee machine does not work. | Connection between the device and the power supply may be defective. | Check the power supply and the cord. |
| The steam knob does not froth. | The container used is not of the correct size or shape. | Use a high and narrow cup. |
| You have used skimmed, soy, rice or other type of milk. | Use whole milk. | |
| All the light indicators turn on red and flash. | There is not enough water in the water tank. | Fill the water tank until the device shows no error. |
| While brewing coffee, the single and double espresso buttons flash red and no coffee is brewed or only drops. | The coffee filter is clogged. | Do not grind coffee too fine and do not exceed the indicated quantity of coffee powder. |
7. Technical Specifications
Model: Power Espresso 20 Barista Pro
- Product reference: 01577
- Power: 2445-2900 W
- Voltage and frequency: 220-240 V, 50 Hz
- Made in China | Designed in Spain
8. Disposal of Old Electrical Appliances
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE) mandates that old household electrical appliances must not be disposed of with unsorted municipal waste. Old appliances must be collected separately for optimized recovery and recycling of materials, reducing impact on human health and the environment.
The [crossed-out wheeled bin symbol] on the product signifies your obligation to dispose of the appliance correctly. If the product contains batteries, they must be removed and disposed of appropriately.
Consumers should contact their local authorities or retailer for information on the correct disposal of old appliances and/or batteries.
9. Technical Support Service and Warranty
This product is under warranty for 2 years from the date of purchase, provided proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use as explained in this manual.
The warranty does not cover:
- Purposes other than intended, misuse, damage, exposure to moisture, immersion in liquid or corrosive substances, or any fault attributable to the customer.
- Disassembly, modification, or repair by unauthorized persons.
- Faults due to normal wear and tear of parts from use.
The warranty service covers manufacturing defects for 2 years, based on current legislation, excluding consumable parts. Warranty is void in case of misuse.
For any product problem or doubt, contact Cecotec Technical Support Service at +34 963 210 728.
