Sharper Image Thunderbolt Jet X-2 Drone

1. Preflight Checklist

• Read all warnings and instructions.
• Ensure the remote control is powered off.
• Install batteries in the remote control. (See page 4 for details)
• Make sure the drone is powered off.
• Charge the drone's battery. (See page 4 for details)
• First-time operators should practice indoors.

2. Getting Started

Choosing a Location

Select a suitable indoor location for initial practice.

Pairing the Drone and Remote

For ease of control, orient the drone so the red rear lights are facing you.

1. Turn on the remote control.
2. Place the drone on a flat, level surface.
3. Push the left throttle stick up and then down to initiate pairing.

The drone's lights will flicker during the pairing process and remain solid once successfully paired.

Important: After a hard landing, turn off the drone and remote, then repeat the pairing process.

3. Operating the Drone

Take Off

There are two ways to launch the drone:

• Press the [Flight/Land Button]. The drone will rise.
• Slowly press the left throttle stick upwards until the drone lifts off.

Landing

There are two ways to land the drone:

• Slowly and carefully press the left throttle stick downwards until the drone lands.
• Press the [Flight/Land Button] for a standard landing.

For an emergency stop, press and hold the [Flight/Land Button] until the propellers stop spinning.

Fine-Tuning and Direction Control

If the drone begins to drift, you can correct its direction using the direction stick on the right side of the remote.

• Hover Up and Down: Use the left throttle stick (up/down).
• Turn Left and Right: Use the left throttle stick (left/right).
• Fly Forward and Backward: Use the right direction stick (up/down).
• Fly Sideways: Use the right direction stick (left/right).

To correct drift, fly the drone to a height of at least 10 feet and use the trim controls.

4. Advanced Modes

Stunt Mode

To perform a stunt, fly the drone to a height of at least 10 feet and press the stunt bumper [Stunt Button].

Auto-Orientation Mode

When the drone is in auto-orientation mode, it will orient itself relative to your current facing. This mode is not applicable when using the trim controls.

The drone's orientation relative to the operator is maintained, simplifying control.

5. Tips & Troubleshooting

Flying Tips

• Do not crash the drone into sand or dirt, as this can clog the gears.
• When first learning to fly, practice lifting off and hovering.
• Maintain a safe distance from walls and buildings.
• Always press the throttle all the way down after a crash or if something gets stuck in the propellers.
• Never fly drones above or near people; sudden changes in wind or other conditions could lead to unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, and respect the privacy and property rights of others.
• Do not modify the drone or use it in any way other than its intended purpose.

Troubleshooting Guide

• Remote switch is turned on, but the remote light does not illuminate:
  1. Check that batteries in the remote are installed correctly.
  2. Turn off the drone and remote controller, then turn them on again.
  3. If the remote light still does not turn on, replace the batteries with new ones.
• During flight, the remote power LED is dim or the remote distance is short:
  1. Remote batteries are low. Land the drone immediately.
  2. Replace old batteries with fresh ones.
• Drone and remote pair properly, but the drone will not lift off:
  1. The drone battery needs charging. Use the USB Charge Cable to connect the drone to a power source.
• After trimming the drone, flight is very unstable and it cannot fly properly:
  1. One or more blades may be damaged. Replace damaged blades with the provided replacement blades and try flying again. (See page 3 for replacement instructions)
  2. Press and hold both joysticks outwards for 3 seconds to reset the gyroscope.
  3. Turn on the drone and remote, then repeat the pairing process. (See page 6 for pairing)
• Remote and drone cannot be paired:
  1. Ensure the remote is within 12 feet of the drone.
  2. Note: If there is more than one unpaired drone within 12 feet, one must be successfully paired before others can be paired.

6. Charging and Battery Information

Charging the Drone

The drone must be charged before each use using the included USB Charge Cable.

• Turn the drone off before charging.
• Connect the USB Charge Cable to the drone's charge port and a power source.
• The indicator light will turn red while the battery is charging and will turn off once the battery is fully charged.
• Charge time is approximately 120 minutes.

WARNING: ONLY USE PROVIDED USB CABLE FOR CHARGING.

Remote Control Batteries

Open the battery cover and install 4 AA 1.5V batteries as shown.

7. Safety Warnings

Not recommended for children under 14 years of age.

As with all electrical products, precautions should be observed during handling and use to reduce the risk of electrical shock.

Adult supervision is required at all times.

• Operate the drone only on smooth, flat surfaces.
• Never fly drones above or near people; sudden changes in wind or other conditions could lead to unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, and respect the privacy and property rights of others.
• The drone shall never be modified or used for anything other than its intended purpose.
• Before each use, an adult should review the product and battery to ensure no damage or hazards exist.
• DO NOT TOUCH SPINNING PROPELLERS. Prevent contact with spinning blades by turning off the remote prior to handling the drone.
• Use caution and pay attention to your surroundings while operating the drone.
• Do not fly the drone into animals, people, or inanimate objects.
• Keep the drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas.
• Do not operate in rain, heavy wind, or any type of severe weather.
• Do not land the drone on wet surfaces.
• Never touch or allow others to touch the drone while it is flying.
• Always turn the drone off when it is not in use.
• Always fly the drone in large, open areas.
• The drone will lose controlling capabilities if flown beyond the maximum recommended altitude of 100 ft. Keep below 100 ft. to avoid potential crashing risks.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Sharper Image name and logo are registered trademarks. Distributed by and © 2021 MerchSource, LLC. Irvine, CA 92618. All rights reserved.

The artwork and design of this manual are protected by US copyright law and may not be reproduced, distributed, displayed, published, or used for any purpose without prior written permission. Altering, removing, or reproducing any of the trademark or copyright notices on this package is not permitted.

PATENT PENDING

8. FAA Warning

This drone weighs 0.20 lbs (93g). As of November 2017, the Federal Aviation Administration (FAA) requires registration of unmanned aircraft weighing more than 0.55 lbs. Visit www.faa.gov/uas/registration for more information. Ongoing compliance with Federal, state, and local laws regarding operation is the owner's sole responsibility.

9. Contents

Inside the Box

• Drone
• Controller
• USB Charge Cable
• Replacement Propellers

10. Propeller Replacement

To replace a broken propeller:

• Pull firmly to remove the broken propeller.
• Push the new propeller on firmly and carefully.
• Each blade has a letter on it (A, B, C). Match the blades with the corresponding letter on the drone.

11. Customer Support

For questions or concerns, please call Customer Support at (800) 374-2744. Before calling, please locate the 10-digit code printed on the back of your remote.

CHOKING HAZARD: SMALL PARTS NOT FOR CHILDREN UNDER 3 YEARS.