DEWERT OKIN RF396B User Manual

User Manual of RF396B

Figure 1: Button layout of the remote control.

• 1: Child lock
• 2: Bed lamp
• 3: Antisnore
• 4: TV position
• 5: Lumbar up
• 6: Lumbar down
• 7: Head up
• 8: Head down
• 9: Foot up
• 10: Foot down
• 12: Massage
• 13: Flat / Zero G

1.1 Child Lock: Click the Child Lock button for 3 seconds to lock or unlock the remote.

1.2 Bed lamp: Click the bed lamp button to open or shut the light under the bed.

1.3 Antisnore: Click the Antisnore button; the bed moves to Antisnore position. Press and hold the Antisnore button for 5 seconds, until backlight flashes, the control sets the current position as Antisnore position.

1.4 TV position: Click the TV button; the bed moves to TV position. Press and hold the TV button for 5 seconds, until backlight flashes, the control sets the current position as TV position.

1.5 Lumbar Up: Press and hold the LUMBAR UP button. The lumbar actuator moves out; stop when released.

1.6 Lumbar Down: Press and hold the LUMBAR DOWN button. The lumbar actuator moves in; stop when released.

1.7 Head Up: Press and hold the HEAD UP button; the head actuator moves out, stop when released.

1.8 Head Down: Press and hold the HEAD DOWN button; the head actuator moves in, stop when released.

1.9 Foot Up: Press and hold the FOOT UP button; the foot actuator moves out, stop when released.

1.10 Foot Down: Press and hold the FOOT DOWN button; the foot actuator moves in, stop when released.

1.11 Zero G (ZG): Click the ZG button; the bed moves to zeroG position. Press and hold the zeroG button for 5 seconds, until backlight flashes, the control sets the current position as zeroG position.

1.12 Massage: Click the MASSAGE button; the massage motor switches massage intensity among 0-1-2-3.

1.13 Flat: Click the FLAT button; the bed goes flat.

FCC Compliance

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ISED RSS Warning

This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radioexempts de licence.

L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

ISED RF Exposure Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.

Le matériel est conforme aux limites de dose d'exposition aux rayonnements énoncés pour un autre environnement. Ce dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux RF.