EPLO E16BP Smart Toilet Installation Manual

1. Installation of angle valve

Draw drain outlet centerline on the floor. Install angle valve at proper position on the wall according to the dimension of toilet.

Illustration showing an angle valve connected to a line and drain outlet.

• Installation Method 1: 5/8" connection.
• Installation Method 2: NPT 1/2 connection.

1. Please use the supplied angle valve when installing this toilet. Use of another angle valve not including a filter may result in blockages in the toilet and bidet waterways.

2. If replacing an existing angle valve, please contact a professional for installation.

2. Installation of battery box

Before activating the power-off flushing function, install a 9V alkaline battery (not supplied) into the battery box in advance. Take out the battery connection cable from the rear side of seat cover. And connect it to the female end of the battery box, ensuring that it is plugged in place. Remove the sticker on the velcro at the bottom of the battery box and place it in the proper position of the ceramic back for easy removal.

Illustration of a battery box with dimensions (48.5mm, 46.4mm, 26.5mm, 17.5mm) and labels for Male buckle (+) and Female buckle (-). A battery is shown inside the box.

1. It is recommended to hire professional personnel for this operation.

2. It is recommended to use 9V high-quality dry battery, such as models 6LR61 or 6F22.

3. There is no battery installed in the battery box in the configuration. It should be purchased by the customer before installation.

4. It is recommended to replace the battery every two years, otherwise there may be a risk of leakage.

3. Cardboard installation

Align cardboard with the centerline of drain outlet. Draw contour line according to cardboard.

Illustration showing a cardboard template aligned with a drain outlet, with a 305mm dimension indicated.

4. Hose

Connect the water inlet and angle valve of the toilet with the matching hose and tighten it.

Illustration showing the connection of a flexible hose between the angle valve connector and the inlet connector of the toilet.

Please use this supplied water supply hose, to ensure optimal flushing performance.

5. Mounting bracket installation

Assemble the mounting bracket with bolts and then install them to the pre-installed flange plate on the ground and lock tight with nuts.

Illustration showing the assembly of a mounting bracket with washer, nut, and bolt, and its installation onto a flange plate.

6. Ceramic toilet installation

Install a sealing flange into drain outlet. Install ceramic toilet on the corresponding position.

Illustration showing a sealing flange being inserted into the toilet drain outlet, and the ceramic toilet being placed over it.

1. Two people are required to carry the toilet.

2. Please clean up the drain outlet.

3. Please make sure ceramic toilet outlet sits perfectly on drain outlet.

7. Screw installation

Put the screw through the fixing sleeve and then install it through the holes (on both sides of the toilet ceramic) to the mounting bracket on the ground. Lock tight. Install the decorative cap on the fixing sleeve.

Illustration showing a screw passing through a fixing sleeve and into the toilet ceramic, connecting to the mounting bracket. A decorative cap is shown being installed.