KUFATEC Adaptive Cruise Control (ACC) Installation Instructions
VW Passat B8
Version 1.3 (28.06.2022)
Contents
- Liability Exclusion
- Copyright
- General notes
- Safety Instructions
- Requirements for the intended use
- Safety Instructions for working on Airbags
- Assembly Instructions
- Removing front grille / replace radar sensor
- Routing cable set (only for PR-Nr. 6K0)
- Connection CAN High & Low / ignition lead
- Connection ground / cut-off point
- Removing trim panel front camera
- Routing / connection additional wire
- Removing steering wheel airbag
- Exchange pushbutton
- Exchange accelerator (only with built in Cruise Control)
- Cable routing (only with built in Cruise Control)
- Coding with Coding Interface
8. Removing front grille / replace radar sensor
The following steps detail the removal of the front grille and the replacement of the radar sensor.
Table 1: Removing front grille / replace radar sensor instructions
| Nr. | Work step | Note |
| 1 | Loosen the marked screws of the front grille. | 4xT25 |
| 2 | Remove the front grille by pulling it out forwards. | |
| 3 | Loosen the screws of the radar sensor and unplug it. | |
| 4 | Afterwards attach the new sensor including the bracket. |
