Super B BM01 Quick Start Guide

Display BM01

The Super B BM01 is a display unit for monitoring battery status. It features indicators for 'State of Charge', 'Voltage', and 'Sel/Prog' (Select/Program) functions. The model number is SB-BM01.

Section A: Connection to Epsilon 12V90Ah

This section details the connection of the BM01 display to an Epsilon 12V90Ah battery.

Step 1: A mounting bracket is attached to the battery's positive and negative terminals. The diagram shows a green [upward arrow] indicating the bracket is placed onto the battery terminals. The display unit connects to this bracket.

Display Unit Wiring

The display unit has four connection terminals on its rear:

• Out
• Bat 1
• Bat 2
• Min

Wires are connected to these terminals. The display unit's connector plugs into a battery's terminal block.

Section B: Connection to Epsilon 12V100Ah/12V150Ah

This section describes connecting the BM01 display to Super B Epsilon 12V100Ah and 12V150Ah batteries.

Step 1: The battery terminal cover is opened.

Step 2: Wires from the display unit are connected. The diagram shows the following wire labels and their corresponding connections:

• ACCESSORY_POWER (Red wire)
• ANSOC (Blue wire)
• GND FUSED (Black wire)

These wires connect to specific points within the battery's terminal block, labeled:

• ACC
• LIN
• SOC
• GND
• HEAT

Step 3: The terminal cover is secured using screws (labeled E, F), and the display unit's cable is routed.

Section C: Connection to Nomia Series

This section outlines the connection of the BM01 display to Super B Nomia Series batteries.

The diagram shows the battery, the display unit, and a "Bi-stable Relay". The display unit's wiring is connected via the relay to the battery's positive and negative terminals. The diagram indicates specific connection points and wire routing, including a label "2x" suggesting two wires for a particular connection.