Make It Real Friendship Bracelet Maker

Introduction

This kit allows you to create beautiful friendship bracelets using various patterns, knots, and beads. Follow the instructions to design and make your own unique jewelry.

What's Included

• 1 Friendship Bracelet Maker
• 23 colors of embroidery thread (12 m / 13.1 yd each)
• 1 piece of elastic cord (3 m / 3.2 yd)
• 2 elastic bands
• 15 bracelet pattern templates
• 3240 beads
• 40 buttons

How to Read Patterns & Levels

Patterns indicate designs and steps. They are organized by difficulty levels:

• Learn: Levels 1-7
• Practice: Levels 8-10
• Try new things: Levels 11-12
• Take on challenges: Levels 13-14
• Flaunt your skills: Level 15

Two main methods are used: Row by Row and Segment Knotting.

Types of Knots

Learn to tie different knots to create your bracelets:

• Forward Knot: Starts on the left, ends on the right.
• Backward Knot: Starts on the right, ends on the left.
• Forward-Backward Knot: Starts left, ends left.
• Backward-Forward Knot: Starts right, ends right.

Making Your Bracelet

Setting Up the Maker

1. Open the Maker and take out the two cylinders. Keep the lid open.
2. Take the small cylinder and insert it into the pattern template.
3. Place the small cylinder with the pattern on the slot furthest from the edge.
4. Take the large cylinder and slide it into the pattern template.
5. Place the large cylinder on the slot closest to the edge.
6. Close the lid.

Setting Up the Strings

1. Start with a pattern (e.g., Pattern #01). Select the colors of the strings used in the pattern.
2. Measure and cut the required lengths of string according to the pattern and template. (e.g., 150 cm / 60 in for Pattern #01).
3. Organize each string and insert them into position in the foam organizer.

Knotting

Follow the pattern sequence, making the type of knot indicated by the arrows. Repeat the sequence until the bracelet is the desired length.

Tip: If a knot flips and shows the wrong color string, pull on the passive string (the one not used to make the knot).

Adding Beads

1. Before adding beads, twist the end of each string and add a small amount of clear nail polish or glue to secure it. Let it dry.
2. Insert beads onto the strings as shown in the diagrams.
3. To create flowers, thread beads in a specific sequence (e.g., 4 pink beads and 1 gold bead, repeated 12 times).

Finishing the Bracelet

1. Tie the end of each braid with a simple double knot.
2. Cut excess string using scissors (ask an adult for permission first).
3. To unhook the finished bracelet, press and turn the tightening wheel.
4. Secure the final knots with a drop of craft glue or nail polish. Allow to dry for 5 minutes and cut off excess cord.

Tips & Care

• When starting the bracelet, try to arrange the strings without overlapping them.
• Before wearing the bracelet, gently pull on each side to ensure it is well secured.
• Tip: Avoid submerging the bracelet in water.
• You can use leftover beads to create your own designs or try different patterns.