TRIXIG Battery Charger
IKEA of Sweden
Introduction
Read the instruction manual before first use. ?
CAUTION
- Do not modify, disassemble, open, drop, crush, puncture, or shred battery.
- Do not expose the battery to rain or water. ?
- Risk of fires and burns. Do not open, crush, heat above 50°C (122°F), or incinerate. ?❌
- Keep battery away from open flame or sunlight to prevent heat build-up.
- Keep battery away from high voltage devices.
- THIS PRODUCT IS NOT A TOY, KEEP AWAY FROM CHILDREN. ?❌
- Ensure that all persons who use this product read and follow these warnings and instructions.
- Do not short-circuit the battery or its cells. ?❌
- In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes.
Battery Charging Indicator
The battery charging indicator provides information about the charging status:
- Pulsating light: Charging in progress ▶️
- Steady light for two minutes/no light: Charging completed ✔️
- A small LED divided into three circles shows the charge amount left in the battery.
Press the button located on the back to see the charge amount. The light will turn off shortly after.
Visual representation of indicators (based on diagram):
- Indicator 1: ☀️☀️☀️ ⚡
- Indicator 2: ☀️☀️ ⚡
- Indicator 3: ☀️ ⚡
- Indicator 4: ⚡
Diagram Description: The diagram illustrates connecting the TRIXIG battery to its charger. It shows the battery pack being inserted into the charger with an audible "Click!". An inset detail shows the USB-C connector being plugged into the charger's port. Below the main illustration, there are visual representations of LED indicators that show the battery's charge level using sun icons (☀️) and a battery icon (⚡) with varying fill levels, indicating different states of charge from low to full.
Good to know
- It is normal for the battery to become hot during charging and it will gradually cool down after charging.
- Charging time may vary depending on remaining charge, battery age, and ambient temperature.
- Charger operation temperature: 0°C to 50°C.
- Disconnect the battery from the power outlet before cleaning or when it is not used.
- Battery should not be left discharged for a longer period.
- Battery should not be charged while in contact with flammable material like textiles.
- This battery can only be used with TRIXIG drill.
- USB-C cable not included.
CARE INSTRUCTION
To clean the unit, wipe with a soft cloth moistened with a little mild detergent. Use another soft dry cloth to wipe dry.
NOTE! Never use abrasive cleaners or chemical solvents since this can damage the product.
Product servicing
Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.
Technical Data
Type: ICBL 10.8-16-USBC-P1
Nominal voltage: 10.8 V d.c.
Rated voltage: 12.0 V d.c.
Capacity: 1.5Ah Lithium-Ion, 16.2Wh
Input: 5.0 V d.c. / 1.0-3.0A (USB-C)
This device conforms to UL STD. 2054.
? For indoor use only
Rechargeable Li-Ion battery cell inside. (Three INR19/66 Li-ion cells connected to a group in series)
Charging Time
- If you use 5.0V 1.0A charge current: charging time < 360 min
- If you use 5.0V 2.0A charge current: charging time < 210 min
- If you use 5.0V 3.0A charge current: charging time < 150 min
Disposal and Recycling
♻️ Li-ion
To preserve natural resources, please recycle or dispose of the battery pack properly. This battery pack contains Li-ion batteries. Consult your local waste authority for information regarding available recycling and/or disposal options. Discharge your battery pack by operating your drill. Then remove the battery pack from the drill housing and cover the battery pack connections with heavy-duty adhesive tape to prevent any short circuit and energy discharge. Do not attempt to open or remove any of the components. ?️
Batteries and rechargeable batteries are not household waste! As a consumer, you are required by law to dispose of all batteries and accumulators, whether they contain harmful substances* or not, at a collection point in your municipality/neighbourhood or via a commercial entity offering battery disposal so that they can be disposed of in an environmentally sound manner.
* marked with: Cd = cadmium, Hg = mercury, Pb = lead
Compliance Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation of the device.
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution!
Make sure that the battery is discharged before removal. Use caution to avoid damaging the battery. Cut and isolate wires one by one to avoid short circuit.
Manufacturer Information
Keep this manual for future use.
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
