Clipsal Saturn™ Range Switches - 4000 Series Installation Instructions

Fascia Fitment

To ensure correct fitment of fascia to grid plate:

1. Locate top fascia clips into the appropriate grid location.
2. Once inserted, snap-in the bottom of the fascia.

Visual Description: Diagram shows two steps: 1. Aligning top clips. 2. Snapping the bottom into place.

Fascia Removal

To remove the front fascia:

1. Locate the screwdriver slot on the edge of the product.
2. Insert a flat blade screwdriver into the slot.
3. Using a levering action, remove the front fascia.

Visual Description: Diagram shows three steps: 1. Locating the slot. 2. Inserting a screwdriver. 3. Levering the fascia off.

Wiring Diagrams/LED Indicator Options

The following options detail LED indicator configurations:

• Option 1: LED permanently on
  Visual Description: Wiring diagram shows LED connected directly across the AC input terminals.
• Option 2: LED on, switch on
  Visual Description: Wiring diagram shows LED connected in series with the switch and load, across the AC input.
• Option 3: LED on, switch off, no Neutral required
  Visual Description: Wiring diagram shows LED connected across the switch contacts.
• Option 4: LED on, switch off, using Neutral
  Visual Description: Wiring diagram shows LED connected between the load terminal and the Neutral terminal.

Notes:

• The LED is factory fitted and is not removable.
• The LED does not have to be connected if not required.
• Connecting the LED across switch contacts (Option 3) may cause some brands of compact fluorescent lamps to flicker when the switch is turned off. This does not damage the lamp but can be rectified by using the Neutral connection (as per Option 4).

Fitting Screw Caps

1. Mount the switch to the wall.
2. Push in screw caps over the mounting screws to ensure electrical isolation.

WARNING: Screw caps must be fitted when the product is installed.

Visual Description: Diagram shows a switch mounted to a wall plate with screws, and screw caps being pushed over the screw heads.

Installation of Labelled Buttons

The Clipsal Saturn™ Series features encapsulated buttons (selected models). Button orientation can be changed to suit horizontal or vertical mounting.

1. Remove the encapsulated button with a narrow object, such as a pen.
2. Replace the button with a label button cap.
3. Buttons can be oriented vertically or horizontally. Simply clasp the button, front and back, and rotate it into the appropriate locking position.

Interchangeable labelled ID button faces are also available (sold separately).

Visual Description: Diagram shows three steps: 1. Removing a button with a pen. 2. Replacing it with a labelled cap. 3. Illustrating vertical and horizontal orientation.

Fitting Dimmer Knob

Simply slide the dimmer knob onto the shaft protruding from the front of the switch fascia.

NOTE: Ensure the dimmer knob is correctly aligned with the dimmer shaft. Fit the fascia first before fitting the knob.

Visual Description: Diagram shows a dimmer knob being slid onto the shaft of a switch.