HERNEST Grey Floating Bathroom Vanity Assembly Instructions
Introduction and Preparation
This document provides step-by-step assembly instructions for the HERNEST Grey Floating Bathroom Vanity. The vanity is a 40-inch wall-mounted unit featuring a rock panel countertop, ceramic basin sink, two drawers, and two storage cabinets.
Important Notice:
- Follow all installation instructions. Please confirm all accessories are preset before installation.
- Do not fully tighten screws during initial assembly. Fully tighten screws only once all pieces are correctly assembled.
- If you encounter any problems during installation, please contact customer service.
- Please unbox the item from the side with an open label and put a carpet on the floor to avoid scratching it.
Recommended installers: 2 people
Estimated installation time: 30 minutes
Parts List
| Item No. | Description | Quantity |
|---|---|---|
| A | Vanity top with integrated ceramic basin sink. | 1 pc |
| B | Vanity cabinet unit with two drawers and two doors. | 1 pc |
| 1 | Mounting screws and wall anchors. | 4 pcs |
| 2 | Sink drain assembly kit. | 1 pc |
| 3 | Cabinet door and drawer handles. | 4 pcs |
| 4 | Drawer knobs. | 4 pcs |
Assembly Steps
Step 1: Initial Setup
The primary components are the vanity top with sink (A) and the vanity cabinet (B).
Step 2: Wall Marking for Mounting
Position the vanity cabinet against the wall where it will be installed. Mark the precise locations on the wall for drilling, corresponding to the mounting points on the cabinet.
Step 3: Drilling and Wall Anchoring
Using an electric drill, create holes at the marked positions. Insert the provided wall anchors and mounting screws (Item 1) into these holes, preparing the wall for cabinet attachment.
Step 4: Mounting the Cabinet
Carefully lift the vanity cabinet (Item B) and align its mounting brackets with the prepared wall anchors. Secure the cabinet firmly to the wall using the screws (Item 1).
Step 5: Attaching Vanity Top and Hardware
Place the vanity top with the sink (Item A) onto the mounted cabinet. Ensure it is properly seated and aligned. Attach the cabinet handles (Item 3) to the doors and drawers, and the drawer knobs (Item 4) to the drawers.
Step 6: Installing the Drain Assembly
Install the sink drain assembly kit (Item 2) into the ceramic basin sink. Follow standard plumbing procedures for connecting the drain to your waste pipe.
