Datasheet for CORNING models including: E62-N3-7LU, E62N37LU, OJFE62-N3-7LU, OJFE62N37LU, Everon 6200 A3-E3-N3 Specification, Everon 6200, Everon, 6200, A3-E3-N3
Corning Optical Communication LLC E62-N3-7LU Remote Unit OJFE62-N3-7LU OJFE62N37LU e62 n3 7lu
File Info : application/pdf, 9 Pages, 524.74KB
DocumentDocumentEveron 6200 A3-E3-N3 Specification Sheet Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 1 Features 1200MHz Transmission Bandwidth over 1 fiber Sub 6GHz Dry contact Alarm Support Band or Channel Selective filter E62-A3 - Access Unit Chassis 8 x 3GPP Band per Remote Up to 200MHz IBW 25dBm Maximum Output Power per Band Cascading up to 6 levels The E62-A3 Access Unit Chassis is a standard 19-inch 2U rack-mounted shelf (1U fan unit included), which serves as the host for EveronTM 6200. The E62-A3 provides coupling access to radio signal sources of multioperator, multi-system, and multi-band, forming digital optical signals and distributing static capacity distribution to fiber-connected other type devices. One A3 supports up to eight optical interfaces connected to E3s (Expansion Unit) or N3RUs (Remote Unit). This document describes the installation procedure for the E62-N3 remote unit. This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC License to operate this device. NOTE: Only authorized person can enter the area where the antenna is installed. And the person is fully aware of the potential for exposure and can exercise control over his or her exposure by leaving the area or by some other appropriate means. Awareness of the potential for RF exposure in a workplace or similar environment can be provided through specific training as part of a RF safety program. Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 2 E62-AU-AC Active Combiner Module The E62-AU-AC Active Combiner Module is the interface to the operator base station signal source equipment. Each module has four QMA ports for signal input from the maximum four operators. One Access Unit can be equipped with up to four modules. In accordance with wireless service provider standards, it is not advised to use digital repeaters as a signal source for Corning solutions. E62-E3-O - Expansion Unit The E62-E3-O Expansion Unit is a standard 19-inch 1U rack-mounted shelf, which serves as the interface between the Primary A3 and the Remote Unit for the capacity expansion of system. E62-N3RU Low Power Remote Unit Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 3 The E62-N3RU is a low-power remote unit supporting cellular technologies on fiber optic cable using the CPRI protocol. The N3 is ideal for multi-operator multi-band, static capacity distribution deployments of cellular services in small-to-medium coverage areas. The N3 supports up to four 25 dBm RF channels. The N3 converts an optical signal to RF and then transmits at the relevant 3GPP band and receives the analog RF signal, conditions it, and converts it back to optical for routing to the E3 or A3. The socket-outlet shall be easily accessible. Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Specifications E62-A3 - Access Unit Chassis Supported Bands Band 600MHz 700 LU 700MHz LUPS 850E MHz 1900MHz 2100MHz 2300MHz 2500MHz TDD C-Band-1 3GPP Band 71 12 & 13 12 & 13 & 14 26 25 66E 30 41 n78 Corning Optical Communications Downlink 617-652 729-756 728-768 859-894 1930-1995 2110-2200 2350-2360 2496-2690 3450-3800 Uplink 663-698 699-716 & 777-787 698-716 & 776-798 814-849 1850-1915 1710-1780 2305-2315 2496-2690 3450-3800 Max IBW 35 27 40 35 65 90 10 194 200 E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 4 C-Band-2 n77 3700-3980 3700-3980 200 Interface Access Unit RF Interface Optical Connector Type Transmission Rate AU-AC modules Band Support Dry contact Alarms Maintenance Interface AU-AC power level (dB) QMA Female 8 x 25 GBps SFP+ Interfaces 6 to 8 optical connections to E3-O or N3 2 optical connections to Secondary A3s 25 GB/s 4 x AU-AC modules per chassis (RF interface with BTS) Full 3GPP Band per Module (up to 200 MHz) 12x 3GPP bands over 1 fiber core (using 2 x Secondary A3) 1x RJ45 (2x in, 2x out) Ethernet RJ45 0dBm to +15 dBm Input Power Range for each port Electrical Electromagnetic Compatibility/Interference (EMC/EMI) Maximum Power Consumption AC Power DC Power 3GPP TS38.113 85W 100-240v AC, 50/60Hz 48VDC ± 20% Environmental Mean Time Between Failure (MTBF) Operating Temperature Storage Temperature Humidity Cooling Installation Ingress Protection Rating > 220,000 hours -10°C to +45°C -40°C to +85°C 0% to 90% (Noncondensing) Active Wall or 19-in Rack IP30 (Indoor) Mechanical AU (Width / Height / Depth / Weight) 440mm / 88mm / 329mm / 8.0kg 17.32in / 3.46in / 12.95in / 17.64lb E62-E3-O - Expansion Unit Interface Optical Connector Type Transmission Rate Cascading Dry contact Alarms Maintenance Interface 16 x 25 GBps SFP+ Interfaces 14x optical connections to N3RU 1x optical connection to Primary A3 or upper level E3 1x optical connection to lower level E3 25 GB/s Up to 5 x E3-O per Optical connection 1x RJ45 (2x in, 2x out) Ethernet RJ45 Electrical Electromagnetic Compatibility/Interference (EMC/EMI) Maximum Power Consumption AC Power DC Power 3GPP TS38.113 65 W 100-240 VAC, 50/60 Hz 48VDC ± 20% Environmental Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 5 Mean Time Between Failure (MTBF) Operating Temperature Storage Temperature Humidity Cooling Installation Ingress Protection Rating > 220,000 hours -10°C to +45°C -40°C to +85°C 0% to 90% (Noncondensing) Passive Wall or 19-in Rack IP30 (Indoor) Mechanical E3-O (Width / Height / Depth / Weight) 440 mm / 44 mm / 220 mm / 6.0 kg 17.32 in / 1.73 in / 8.66 in / 13.23 lb E62-N3RU Low Power Remote Unit System Maximum RF Bands per Access Unit Maximum RF Bands per Remote Unit Maximum RF Bands per System Maximum Access Units per System Maximum E3s per Primary A3 Maximum E3s cascaded Maximum N3s cascaded Frequency Range Bandwidth per Channel (Downlink & Uplink) Digital Bandwidth per Channel (Downlink & Uplink) Bandwidth per System (Downlink & Uplink) MIMO System Delay Adjustment 4 8 12 3 (1 x Primary / 2 x Secondary) 8 5 6 DL: 729MHz-756MHz; UL: 699MHz-716MHz & 777MHz-787MHz 200 MHz (Contiguous) LTE: 5/10/15 MHz 1200 MHz 2x2 | 4x4 Up to 50.00 µs Forward Path (Downlink) Maximum Composite Output power Output Power Accuracy Maximum Input Power Ripple Error Vector Magnitude Manual Attenuation Control System Delay (1A3+1E3+1N3) Reverse Path (Uplink) Maximum Output Power per Channel Output Power Accuracy Maximum Input Power Ripple Manual Gain Control Noise Figure (1A3+1E3+1N3) IIP3 Interface Antenna Interface (All bands) Transmission Connector Type Corning Optical Communications f >2.5GHz 25 dBm 1.7GHz< f <2.3GHz 23 dBm f <1GHz 17 dBm ±2 dB +15 dBm 4 dB peak to peak <3.5% @ 256 QAM 30 dB @ 1 dB/step (A3:20 dB, N3RU:10 dB) 12 µs -15dBm @ f >2.5GHz; -17dBm @ 1.7GHz< f <2.3GHz; -23dBm @ f <1GHz ±2 dB -25dBm 4 dB peak to peak 30dB @ 1dB/step (A3:20dB, N3RU:10dB) 10dB @ Maximum Gain -10dBm QMA Female (External Antenna version) 2 x 25 GBps SFP+ Interfaces 1x optical connection to Primary A3, upper level E3 or N3 E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 6 Transmission Rate Optical Fiber Length Cascading Maintenance Interface 1x optical connection to lower level N3 25 GB/s 10km Up to 5 x E3-O per Optical connection Ethernet RJ45 Electrical Electromagnetic Compatibility/Interference (EMC/EMI) Maximum Power Consumption DC Power 3GPP TS38.113 75 W 48VDC ± 20% Environmental Mean Time Between Failure (MTBF) Operating Temperature Storage Temperature Humidity Cooling Installation Ingress Protection Rating > 220,000 hours -10°C to +45°C -40°C to +85°C 0% to 90% (Noncondensing) Passive Ceiling or Wall IP30 (Indoor) Mechanical N3 (Width / Height / Depth / Weight) Integrated Antenna Version N3 (Width / Height / Depth / Weight) External Antenna Version 310 mm / 83 mm / 310 mm / 4.5 kg 12.20 in / 3.27 in / 12.20 in / 9.92lb 310 mm / 83 mm / 310 mm / 4.5 kg 12.20 in / 3.27 in / 12.20 in / 9.92lb Regulation FCC, UL62368-1, UL 2043 Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 7 System Topology Local Maint ena nce Terminal Remot e Access Netwo rk Management Syst em Primary A3 Band 1_A Band 1_B OP1/AU OP2 OP3 Fiber Fiber Fiber Band 1_C Band 1_D OP6 AU1 AU2 Fiber Fiber Fiber Band 2_A Band 2_B Band 3_A Band 3_B OP1/AU Secondary A3 E3-O-1 E3-O-2 E3-O-3 Fiber Fiber slave master slave master slave master OP1 OP2 OP13 OP14 OP1 OP2 OP13 OP14 OP1 OP2 OP13 OP14 slave Band1_MIMO 4x4 Band2_MIMO 2x2 Band3_MIMO 2x2 Master N3RU-1 Fiber slave Band1_MIMO 4x4 Band2_MIMO 2x2 Band5 Band6 Fiber slave Band2_MIMO 2x2 Band3_MIMO 2x2 Band4_MIMO 2x2 Band5 Band6 N3RU-2 N3RU-3 Maximum 6 daisy chained E3+N3 under A3 Band 4_A Band 4_B Band 5 Band 6 OP1/AU Secondary A3 Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 8 Corning Optical Communications LLC · 4200 Corning Place · Charlotte, NC 28216 USA 800-743-2675 · FAX: 828-325-5060 · International: +1-828-901-5000 · www.corning.com/opcomm Corning Optical Communications reserves the right to improve, enhance, and modify the features and specifications of Corning Optical Communications products without prior notification. A complete listing of the trademarks of Corning Optical Communications is available at www.corning.com/opcomm/trademarks. All other trademarks are the properties of their respective owners. Corning Optical Communications is ISO 9001 certified. © 2020 Corning Optical Communications. All rights reserved. Corning Optical Communications E62-A3-E3-N3 Specification Sheet | 28 March 28, 2022 | Page 9