User Manual for UMLo models including: N3 Cordless Stick Vacuum Cleaner, N3, Cordless Stick Vacuum Cleaner, Stick Vacuum Cleaner, Vacuum Cleaner, Cleaner
DIY Vacuum Cleaner Repair: UMLo vacuum cleaner manuals
File Info : application/pdf, 8 Pages, 5.31MB
DocumentDocumentPlease do not hesitate to contact us whenever you want, we are always here for you! support@umlohome.com MODEL:N3/N3S MADE IN CHINA Important Safety Instructions ------------------- 1 Product Parts List ------------------------------------ 3 Product Overview ------------------------------------- 4 Assembly and Combination --------------------- 5 Charging -------------------------------------------------- 6 Using ------------------------------------------------------- 7 Product Parameter ----------------------------------- 7 Maintenance and Cleaning ----------------------- 8 Troubleshooting -------------------------------------- 10 Warranty Policy ---------------------------------------- 11 IMPORTANT SAFETY INSTRUCTIONS Do not place the vacuum cleaner close to heat sources, radiation, or burning cigarettes. · Do not use the appliance to remove the following objects. 1. All liquids such as water and solvents. 2. Lime, cement, ash, and other Construction dust and garbage. 3. Hot objects, such as cigarette butts. 4. Sharp debris, such as glass shards, etc. 5. No flammable and explosive articles, such as gasoline or alcohol products. · Do not let children play with and operate the vacuum cleaner to prevent accidents. · Your vacuum cleaner is an electric appliance: it must be used inappro priately. Do not leave the operating vacuum cleaner unattended. · The power must be turned off during cleaning, maintenance, or when in storage. · Do not pull the power plug to turn off the vacuum cleaner. Hold the plastic part of the plug to remove it from the power socket. · The power supply voltage must correspond to that of the vacuum cleaner charging voltage. · Keep the power cord away from sharp objects to prevent it from being damaged. · To prevent fires do not immerse the vacuum cleaners in water, do not expose them to any heating appliances; · Do not drag the power cord when moving the charging station. · In the case of the below situations do not use the vacuum cleaner and send it immediately to the nearest approved maintenance facility if: -The vacuum cleaner fell and consequently damaged -The power cord is damaged. · Stop operating the vacuum cleaner if the suction inlet is blocked to prevent damages (such as overheating) to the motor or deformations to the vacuum plastic part occasioned by overheating motor. 1 IMPORTANT SAFETY INSTRUCTIONS Battery charging signal 1. It may take you a long time for charging under the following circum stances: a. Room temperature is higher than 30°C; b. Recharge immediately after the vacuum cleaner has stopped operating. 2. Always recharge the vacuum cleaner after each usage no matter how long it has been used. 3. Unplug when not charging. 4. When not in use for more than two months the vacuum cleaner should be disconnected from the power supply. To ensure a longer service life, the vacuum cleaner must be charged once every two months. 5. The vacuum cleaner or adapter may become hot during charging so take the necessary precautions to avoid contact. 2 PRODUCT PARTS LIST 1 2 3 6 4 5 7 8 9 MODEL:N3/N3S 10 User Guide Retractable Metal Tube 1 Main Motor 1 Floor Brush 1 é2-in-1 Brush 1 Long Crevice 1 Filter 2 Wall Bracket 1 Adapter 1 User Manual 1 User Guide 1 3 PRODUCT OVERVIEW Suction Mode Switch Button Battery Indicator Main Motor Retractable Metal Tube Charging Port Power Switch Dust Box Dust Box Open Button Push Buttoh Floor Brush 4 ASSEMBLY AND COMBINATION * Attach different accessories for different tasks as illustrated. * Install vacuum cleaner in the right direction to avoid airflow issues or not working. CHARGING * The battery must be fully charged before the first usage as the product is delivered non fully charged for safety. * Please use the original charger(26.5V). It takes about 4-4.5 hours to fully charge the battery. * The vacuum cannot be turned on when charging for safety. Battery Indicator Battery Indicator Insert the power plug into the charging port; connect the power adapter with the power supply. -Three blue lights flicker successively: Charging -Three steady lights: Charging complete 5 6 USING Battery Indicator Suction Mode Switch Button Power Switch - Three solid green lights: Full Power - Two solid green lights: Medium Power - One solid green light: Low Power - One blinking green light: Needs a Recharge 2-1 Press the power switch to turn on the vacuum, press twice to change to the Max mode, and then press it again to turn it off. 2-2 Press the Suction Mode Switch Button to switch the power suction mode between MAX and MIN. PRODUCT PARAMETER Model NO. N3 Rated Voltage 22.2V Power Adapter Output 26.5V/500mA Net Weight 2.4lb Power Adapter Input 100-240V,50/60Hz Battery Capacity 2200mAh 7 MAINTENANCE AND CLEANING 1Dust Box Cleaning Push 1 Please empty the trash of the dust box and make sure the amount of the trash is not over the Max Line. 2 Open the dust box to empty the trash. 3 Rotate the dust box and take it off. 4 Rinse the dust box with cold water. 5 Make sure completely dry before using again. 8 2. Filters Cleaning and Installing 1 Rotate the primary filter and take it off. 2 Take out the filter. 3 Wash them with cold water. 4 Wait until they are thoroughly dry. 5 Install the filter to the primary filter. 6 Install all filters to the main motor. Please Note: * Never operate the vacuum without all filters. * Wash filters with cold water when they are dirty. * Replace the white filter according to your use frequency. 7 Rotate the dust box, then fix it in place. 9 TROUBLESHOOTING * If the solutions below cannot solve the problem or the issue you met is not listed, please contact us via support@umlohome.com. Q1. The vacuum has no suction power A1. The dust box is full. A2. The filters are blocked. 1. Clean the dust box after use to prevent build-ups. 2. Clean all filters with cold water and install them until they are thoroughly dry. Please replace the white filter if it couldn't filter out dust anymore. A3. Accessory is blocked. 3. Check and remove the blockage in attachments. Q2. Running time shortened A1. Battery is not fully charged. A2. Accessory is blocked. A3. Ambient temperature is too high or too low. 1. Please use the original adapter to charge the battery. It usually takes 4-4.5 hours to be fully charged. 2. Check and remove the blockage in attachments. Clean all filters if necessary. 3. Your vacuum should be operated at a suitable ambient temperature. Q3. No charging A1. Use the wrong adapter. A2. The outlet is not working. A3. Ambient temperature when charging is too high or too low. 1. Please use the original adapter to charge the battery. The original adapter is 26.5V. 2. Please try another outlet to charge. 3. Charge the battery under the right temperature environment(5-40) A1. The dust box is full. A2. Accessory is blocked. Q4. Abnormal noise 1. Clean the dust box after use to prevent build-ups. 2. Check and remove the blockage in attachments. You could get more operation guidance and maintenance tips on UMLo YouTube: https://bit.ly/umlo-n3-y2b 10 WARRANTY POLICY NOTE: THIS WARRANTY TERM GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. 12-month Warranty & Lifetime Customer Support Only apply to eligible purchases made directly from the UMLo authorized distributors. Warranty coverage applies to the original owner and to the original product only and is not transferable. How to initiate a warranty claim If your appliance operates improperly while in use under normal household conditions within the warranty period, please contact our customer support [support@umlohome.com] to fill out the warranty form to initiate a warranty claim. All rights are reserved by UMLo. 11