Richmat HJ HJH13D Ble Smart Home Product Function Manual

Remote Control Button Silicone Diagram

The remote control features the following buttons:

• Button 1: Head motor extends.
• Button 2: Head motor retracts.
• Button 3: Foot motor extends.
• Button 4: Foot motor retracts.
• Button 5: Motor moves to the 'M' position (memory position) with a single press.
• Button 6: Bed light control. Tap to turn on/off the bed light. Long press to turn on the flashlight, release to turn off the flashlight.
• Button 7: One-key reset. All motors retract to their minimum stroke position and reset after power-on.

Multiplexing Function (Button 5): Long press button 5 for approximately 3 seconds. The backlight will flash, and the buzzer will sound, indicating that the current motor position has been recorded. This setting will be cleared after a power failure.

Remote Control Function Description

Coding Method

To match the control box code: Press and hold the head up button (1), foot up button (2), and the control box code matching key simultaneously. The buzzer will sound, indicating successful code matching.

Precautions

To protect the reliability and safety of the motor and control box, do not switch the buttons frequently.

Caution: FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.