User Manual for CREALITY models including: Sprite Extruder, Water Cooling Hotend, Sprite Extruder Water Cooling Hotend

水冷散热套件-说明书

Go Manual

Myosuploads3.banggood.com

水冷散热套件使用说明书 - Banggood

如图所示，将水冷散热块安装在原散热块位置并用配件包中的M2×12螺栓连接加热块,然后将喷. 头套件固定在原安装支架上。 3. As shown in the figure, replace the fan ...

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
  

  File Info : application/pdf, 8 Pages, 867.48KB

  Document Document

V1.0
Sprite Extruder Water Cooling Hotend User Manual 


 Packing list

 Water cooling pump
 Cooling tube

 Power Adapter

 Water cooling block
M3x16 M3x16 bolts

 Clamp
M2x12  M2x12 bolts T nut

 Installation  Installation

1. 4
1. 4 1. Detech the Sprite Extruder by removing the 4 screws.

2. ()
2. () 2. Remove the fan cooling component(heatsink and fan) from Sprite Extruder and keep the mounting screws for the water cooling component.

   

3. M2×12,  3. As shown in the figure, replace the fan cooling component with the water cooling component, then install the original heating block kit with M2×12 bolts. Remount the Sprite Extruder on the original mounting bracket.

4.  inout 4. Cut the cooling tube into two equal lengths (the length of the cooling tube
varies depending on the machine). Attach the 2 cooling tubes through the fixing nut and tighten the nut to fix it (Pay attention to the "IN" and "OUT" label).

"11307"-4 %3"8/

%"5&

$)&$,&% *446&%

1"35/".&

(FOFSBM5PMFSBODF3FGFSFODF G N
(#5,

%3"8*/(/0


4)&/;)&/$3&"-*5:%5&$)/0-0(:$0
-5% ."5&3*"- '*/*4)

4*;& 4$"-&

"



6/*5 ..

3&7 4)&&5'

5. outout in 5. Attach the other end of cooling tubes onto the water cooling pump interface in
the same way (Pay attention that the ''OUT'' port on the water cooling pump should be connected to the ''IN'' port on the cooling block).

6. ; 3/4 6. Use a flat head to unscrew the sealing cap and fill it with coolant , then tighten the sealing cap after filling. (DO NOT USE WATER as it will damage the pump. Replenish when the liquid level is lower than 3/4).

7. M3×16 7. Fix the clamp on the gantry on top of the printer with M3×16 bolts and T nuts.

8.  8. Mount the water cooling pump kit into the clamp. Adjust the position as shown
in the following figure.

9.  9. Lastly, connect the water cooling kit to the power adapter to start printing.

MADE IN
CHINA