Altronix RBR1224 Electronic Toggle/Ratchet Relay
Specifications
- 12VDC to 24VDC operation.
- Positive (+) or negative (−) ultra sensitive trigger (3VDC to 24VDC @ 20mA minimum).
- DPDT contacts rated at 2A/120VAC/28VDC.
- Relay status LED.
- Remote LED status output.
- DIN Rail mountable (order part # CLIP4).
- Board dimensions (W x L x H): 2.5"x 3" x 1" (63.5mm x 76.2mm x 25.4mm)
Diagram
The unit features two rows of terminals. The top row includes:
- TRG +
- POS (+)
- C (Common)
- NO (Normally Open)
- NC (Normally Closed)
The bottom row includes:
- LED
- TRG −
- NEG (−)
- C (Common)
- NO (Normally Open)
- NC (Normally Closed)
A small circular indicator light (likely the status LED) and a rectangular area are also depicted on the board.
Applications
- Use with PGM alarm control panel outputs.
- Electronically shunt-alarm zones, door control or keypads.
- Interfaces with wireless receivers.
- Converts momentary to maintained contacts.
Installation Instructions
- Connect aux power to terminals marked [POS (+)] and [NEG (−)].
- The relay will change state to latch ON or OFF by the application of a positive momentary trigger voltage to the terminals marked [TRG +] and [POS (+)] or negative momentary trigger voltage to terminals marked [TRG −] and [NEG (−)].
- Relay status LED is lit when relay is energized. To use a remote LED, connect negative lead of remote LED to terminal marked [LED], connect positive lead of LED to [POS (+)].
