Assembly Instructions

Important Warnings:

WARNING: DO NOT STAND, SIT OR LEAN ON THIS UNIT. DO NOT USE THIS UNIT AS A STEP LADDER OR AS A CHOPPING SURFACE. KEEP AWAY FROM CHILDREN AND BABIES. ADULT ASSEMBLY REQUIRED. USE ONLY ON A FLAT SURFACE. DO NOT USE THIS UNIT UNLESS ALL BOLTS AND SCREWS ARE FIRMLY SECURED.

Care Instructions:

TO BE ASSEMBLED ON A CLEAN, DRY AND SMOOTH SURFACE. WIPE CLEAN WITH A SOFT DAMP CLOTH. NEVER USE SCOURERS, ABRASIVES OR CHEMICAL SOLVENTS. CHECK AND TIGHTEN ALL PARTS REGULARLY. KEEP AWAY FROM MOISTURE AND DIRECT SUNLIGHT. STORE IN A DRY PLACE. FOR INDOOR AND DOMESTIC USE ONLY.

MAXIMUM SAFE LOAD: 100KG.

Parts List:

• AX3
• BX1
• CX1
• DX1
• EX1
• FX1
• IX1
• GX12 (M6x12mm)
• HX2 (M6x32mm)

Assembly Steps:

STEP 1: Remove Part C&D plastic sleeve by hands.

[Diagram showing parts C and D being handled]

STEP 2: Affix Part D with A, G&I.

[Diagram showing part D being attached to parts A, G, and I using screws]

STEP 3: Affix Part D as per diagram with B&H.

[Diagram showing part D being attached to parts B and H using screws]

STEP 4: Affix Part D as per diagram with F.

[Diagram showing part D being attached to part F using screws]

STEP 5: Affix Part B as per diagram with C, G, H&I.

[Diagram showing part B being attached to parts C, G, H, and I using screws]

STEP 6: Take the E out of the vacuum bag and pat soft with your hands.

[Diagram showing part E being removed from packaging and fluffed]

STEP 7: Affix Part B as per diagram with E.

[Diagram showing part B being attached to part E]

STEP 8: Final Assembly.

[Diagram showing the fully assembled Billow Lounge Chair]

Note: Do not tighten the screws fully during assembly. Fully tighten screws after the final assembly steps.