15 thg 6, 2024 — To reduce the risk of electric shock, proper grounding is required for the chair. ... Add 3 teaspoons of low-foaming dishwasher detergent and 2 ounces of bleach ...
head and impeller in place.Fill the tub basin w. h about 5 gallons of wate. Turn the pipeless jet on.Add 3 teaspoons of low-foaming dishwasher detergent and 2 ounce. of bleach to the tub basin.Run pipeless jet for 10-15 min. es and drain the tub basin.Clean the exterior of the pedicure spa with a s.
USER MANUAL MAYAKOBA PEDICURE SPA CHAIRS MAYAKOBA is an AYC's registered trademark for beautiful and functional pedicure spas, spa chairs, spa tubs, and other nail salon furnishings. We strive to continue to bring you outstanding pedicures spas along with modern and classic salon furnishings. | Page 4 of 10 III. Grounding Instruction DANGER WARNING! To reduce the risk of electric shock, proper grounding is required for the chair. These items are equipped with a grounded plug. When assembling the pedicure chair, insert the grounded plug into a grounded socket with proper installation and suitable local voltage. Incorrect grounding may cause electrical shock. If you have any questions about this item, please consult a licensed electrician. If the plug sent along with the chair does not match your socket, please do not modify the socket. Please do not use a plug adapter. Ask technicians to install a suitable socket. Modification from the original manufactured specifications will void all warranties expressed or implied. IV. Changing the Fuse In cases of an electrical shortage, the fuse may burn out. The user can open the fuse cap with a screwdriver and replace it with an appropriate fuse. After the replacement, put the fuse cap back on. If there are any questions, please consult a licensed electrician. V. Important Precautions Please contact a local, qualified plumber to install your new Mayakoba pedicure spa chair. It cannot operate properly or safely unless it is provided with adequate electrical power, enough water pressure, proper water temperature and the required drain facilities. Information on these important subjects are contained in this manual. We urge you to read it carefully to make sure these requirements are met. SAFETY NOTICE! 1. Excessive water temperature is dangerous and should be checked before use. Maximum operating water temperature should not exceed 100 °F (38 °C) and the maximum supply water temperature should not exceed 125 °F (65 °C). 2. Always enter and exit the pedicure spa slowly and carefully. 3. Never bring and/or operate any electrical devices into or near the spa. 4. Do not stand in the whirlpool tub! VI. Installation Summary The installation must comply with all plumbing and electrical codes. A licensed plumber should complete the plumbing of the spa. Page 5 of 10 WARNING! GOVERNING NOTE: Failure to comply with federal, state or local codes and ordinances will result in the warranty being considered null and void. How to comply with terms: Select a level location where the floor can support the weight of an occupied spa. For the seat back to fully recline, the spa base must be placed a minimum of 16-20 inches from the wall. Connect the water supply lines with cold and hot inputs. Connection: Cold ½ NPT Hot ½ NPT Connect the floor drain connection to the P-Trap (if you are using a wall drain you will need to install a discharge pump). Connection: P-Trap 1½ - inch drainpipe Place the drain plug into the drain from the top (the drain plug may need to be adjusted so that it forms a tight seal around the drain). Install the faucet handle by inserting it into the faucet in front with the red and blue indicator facing up. Then, tighten the lock screw with a small flathead screwdriver. Attach the sprayer to the sprayer hose (be sure to cut the zip tie around the sprayer hose). Plug the power cord into a GFCI outlet. VII. Common Specifications Shipping Dimension & Weight Net Dimension & Weight Capacity of Tub Switch Power Source Plumbing Source Warranty Pedicure Spa & Massage Chair Pedicure Spa & Massage Chair Dedicated 15Amp Wall Outlet Required Pipeless Jet motor Discharge Pump (Optional) Massage System Hot Water Cold Water Drain 1 Year (See Warranty for covered parts) Dimension s will vary Dimension s will vary 206 - 250lbs. 150 - 194 lbs. 4.5 Gallons (approximate) On/Off Air Activated Switch 120V, 0.4 A, 60Hz 115V, 3.2 A. 60Hz 120V, 60Hz ½" (fitting provided) ½" (fitting provided) VIII. Operating the Pedicure Spa Page 6 of 10 After the spa has been installed and the plumbing and electrical connections have been completed, clean the tub and wipe dry with a clean towel. Follow these instructions to test the pedicure spa: 1. Turn the "drain handle" (2) to open/close the drain. *NOTE: If drain will not open, check the water stopper and tighten/loosen the adjustment screw as needed. 2. Fill the tub until the pipeless jet is completely submerged in water by lifting the faucet handle (1). Water will release from the spout (6). NOTE: For no plumbing pedicure units, please fill until max fill line. 3. Press the left button (3) to turn on/off the pipeless or no plumbing jet. 4. Press the right button (4) to turn on/off the discharge pump (if unit is equipped with one). 5. Use sprayer (5) to rinse tub. NOTE: For no plumbing, please physically empty and clean the basin. Floor drain plumbing will allow Pipeless Pedicure Chairs to drain out water automatically no discharge pump needed. *Example tub in picture: SIENA Pedicure Tub Page 7 of 10 IX. Cleaning and Disinfecting the Pedicure Spa Please follow these instructions to clean and disinfect the pedicure unit: Between Each Customer 1. Drain all water, remove debris, and/or remove foot liner from the spa. 2. Clean the spa with soap or detergent and water. 3. Spray the surfaces and walls of the spa using the attached sprayer. For no plumbing pedicure chairs, rinse under sink. 4. Wipe the spa dry with a clean towel. If you have purchased a no plumbing unit you will also replace the foot liner at this time. Daily Flushing of the Pipeless Jet System The spa must be thoroughly cleaned after the last pedicure of the day in the following manner: 1. Remove the jet cover by turning counter-clockwise. 2. Remove all debris trapped behind the cover and/or impeller. 3. Clean all parts with a mild soap, vinegar solution, or detergent and water. 4. Do not run the pipeless jet without the jet cover/magnetic head and impeller in place. 5. Fill the tub basin with about 5 gallons of water. 6. Turn the pipeless jet on. 7. Add 3 teaspoons of low-foaming dishwasher detergent and 2 ounces of bleach to the tub basin. 8. Run pipeless jet for 10-15 minutes and drain the tub basin. 9. Clean the exterior of the pedicure spa with a soft cloth and mild detergent. Biweekly Cleaning of the Pipeless Jet System In addition to the daily cleaning, the follow cleaning procedures must be performed every other week: 1. Fill the basin with 5 gallons of water. 2. Turn the pipeless jet on. 3. Add 3 teaspoons of low-foaming dishwasher detergent and 2 ounces of bleach to the tub basin. Page 8 of 10 4. Run pipeless jet for 10-15 minutes. Let the water sit overnight in the tub (6-10 hours). 5. Run the pipeless jet for 5 minutes and drain the tub basin. 6. Follow the instructions in "Daily Flushing of the Pipeless Jet System." Cleaning and Disinfecting Records HEALTH CODE NOTICE: A record must be made of the date and time of each cleaning and disinfecting as required by the above procedures, indicating whether the cleaning was "daily" or "bi-weekly". This record should be made available when requested by customer or inspector. X. Environment for Chair Operation 1. Please do not operate the units in damp areas (such as a bathroom) to prevent electrical shock or other accidents. 2. Please place the units only on a flat surface. 3. Please make sure to leave a minimum of 16-20" of space behind the chair, so that there is sufficient room to recline the backrest. 4. Do not operate this item in direct sunlight or in a place with high temperatures. Exposure could fade or harden the material. 5. Items may cause abrasion to the floor. We recommend that a floor mat or carpet be placed under the chairs in order to minimize abrasions and to reduce noise from the pedicure chairs. XI. Warranty Shop Salon City provides pedicure spas with the highest standards for quality materials and workmanship. Accordingly, we warrants its products as follows: To the original owner of the Mayakoba pedicure spa chairs, we may repair or replace, at its discretion, any pedicure spa chair deemed to be defective in material or workmanship upon inspection by an authorized representative of Shop Salon City. This warranty covers only the listed components for a period of one year, dating from the date of delivery and does not include labor. · There are no other warranties, express or implied. Owner is responsible for all labor and shipping charges necessary to replace or repair the pedicure spas. Shop Salon City will not be liable for any consequential, incidental, or contingent damages. If a pedicure spa needs to be exchanged, it will be limited to supplying a replacement pedicure spa of comparable style and size. Page 9 of 10 Shop Salon City may at its own discretion use refurbished parts or pedicure spas for repair and replacement purposes. This warranty is null and void if the pedicure spa is removed from its place of initial installation or is not installed in accordance with federal, state, or local codes and ordinances. Furthermore, this warranty does not apply if the pedicure spa has been subject to misapplication, misuse, improper installation or maintenance, negligence, improper cleaning, or other circumstances beyond Shop Salon City's control. The following are examples of what is not covered by the warranty: 1. Natural wear and tear including but not limited to staining, fading, or discoloration of the vinyl seat, armrests, or footrest. 2. Damage resulting from standing in the basin. 3. Damage to pump parts and/or motor parts due to obstruction in plumbing lines, drains, etc. 4. Staining, fading, or discoloration of plastic surfaces due to exposure and/or the use of harmful cleaning agents or chemicals. 5. Staining, fading, or discoloration caused by improper or poor water additives not related to maintenance of proper water. 6. Malfunctions or damage caused by improper installation, including not meeting local and state plumbing, electrical, and building codes. 7. Freight damage, misuse, neglect, abuse, and natural disaster. 8. Unauthorized repairs. 9. Natural wear and tear of remote control including broken buttons, cracked screens, or water damage. XII. Warranty (Continued) By using the pedicure spa chairs, Owner agrees that the obligation of Shop Salon City shall not extend to indirect or consequential damage or injury which may result from pedicure spa use. Owner agrees that the obligations of Shop Salon City are limited to those set herein and that there are no other obligations except those expressly agreed to in writing by Shop Salon City. No dealer or other person has any authority to bind Shop Salon City to changes or additions to this warranty or its products; accordingly, Shop Salon City is not responsible for any such warranties or representations. Page 10 of 10Microsoft Word for Microsoft 365 AYC group llc