Dahua WizSense PTZ Camera Installation Guide

Product Overview and Dimensions

This document provides essential instructions for the installation of the Dahua WizSense PTZ (Pan-Tilt-Zoom) surveillance camera. It details the mounting process, component identification, and connection procedures.

Key Dimensions:

• Height: 160.0 mm [6.30 inches]
• Width: 119.0 mm [4.69 inches]
• Depth: 415.9 mm [16.37 inches]
• Base Diameter: 262.0 mm [10.31 inches]
• Other measured dimensions include: 185.9 mm [7.32 inches], 25.9 mm [1.02 inches], 247.6 mm [9.75 inches], 182.0 mm [7.17 inches], 115.0 mm [4.53 inches], 84.0 mm [3.31 inches], 270.0 mm [10.63 inches].

Important Symbols Used:

• ⚠️ [Warning]: Indicates important information for safe operation or potential hazards.
• ? [Prohibited]: Denotes actions that must not be performed to avoid damage or malfunction.

Package Contents and Components

The camera package typically contains the following items, as illustrated in the initial diagrams:

• 1x Camera Unit
• Mounting Brackets (various types for different installations)
• Screws and Anchors (e.g., 4x, 6x, specific types labeled A, B, C, D in diagrams)
• Cables (e.g., power, network, connection cables)
• Installation Guide

Note: The exact contents may vary based on the specific product configuration.

Installation Procedure

Step 1: Mounting Location Preparation

Select an appropriate mounting location. Ensure the mounting surface (wall, ceiling, or pole) is capable of supporting the camera's weight and provides a clear view of the surveillance area. The diagrams show different mounting scenarios.

Step 2: Install Mounting Bracket

Secure the chosen mounting bracket to the prepared surface using the provided screws and anchors. The diagrams illustrate wall mounting (Steps 1-2) and ceiling mounting (Step 2).

Step 3: Attach Camera to Bracket

Mount the camera unit onto the installed bracket. Ensure all locking mechanisms are engaged for a secure fit.

Step 4: Connect Cables

Connect the necessary cables to the camera. This includes power, network (e.g., Ethernet), and any other required interfaces. The diagrams detail the connection points for SIM card, Micro-SD card, and internal wiring.

Step 5: Insert SIM and Micro-SD Cards

Access the internal compartment by opening the camera cover. Insert the Micro-SD card into its slot for local storage and the SIM card into its slot for cellular network connectivity, as indicated in the diagrams.

Step 6: Power On and Reset

After all connections are made and cards are inserted, power on the device. The diagrams indicate a reset button, which may need to be pressed for approximately 10 seconds to initialize or reset the camera.

Step 7: Final Assembly and Verification

Complete the installation by ensuring all components are securely fastened. Step 7 in the diagrams shows the camera fully mounted on a wall bracket. Additional diagrams illustrate ceiling and pole mounting configurations.

Mounting Options

The camera offers versatile mounting solutions:

• Wall Mount: Standard installation on a vertical surface.
• Ceiling Mount: Installation suspended from an overhead surface, often using a pole or bracket.
• Pole Mount: Secure attachment to a cylindrical pole using appropriate mounting hardware.

Cable Wiring Details

The diagrams provide specific guidance for connecting internal wires:

• Diagram A & B: Show wire groupings for connections labeled '1+2' and '3-4-5-6'.
• Diagram C: Illustrates connections for '1+2+3' (RED) and '4-5-6' (RED).
• Diagram D: Details connections for '1+2+3+4' (BLACK), '5-6' (RED), and '1+2+3+4+5+6'.

Adherence to wire colors (BLACK, RED) and numbering is crucial for correct electrical connections.