APS Grille Installation Instruction
Rev. 190701
Application
For 2008-2010 Ford F-250 Not For FX4 4WD/Harley Davidson
2008-2010 Ford F-350 Not For FX4 4WD/Harley Davidson
2008-2010 Ford F-450 Not For FX4 4WD/Harley Davidson
2008-2010 Ford F-550 Not For FX4 4WD/Harley Davidson
Parts List
| Part# | Item | Part Name | QTY | Description | Item | Part Name | QTY | Description |
|---|---|---|---|---|---|---|---|---|
| F65327C/J/S | 1 | Billet Grille | 6 | Stainless steel | 4 | Screws | 18 | 8 × 1 1/4" |
| 2 | Flat Tabs | 4 | 8# | 5 | U- Clip Nuts | 18 | ||
| 3 | 2-Hole Tabs | 8 |
Install Notes
Overlay ✓ Replacement ✗ Drill ✗ Cut ✗
Installation Steps
Identify the grille & hardware with parts list.
Illustration: A diagram showing the billet grille pieces and hardware components.
Pop hood, remove the black plastic cover (on top of OEM grille / front panel) from vehicle. This will allow access to the rear of the grille shell.
Place one screw through each of the welded tabs on the billet grille.
Place a U-clip nut over each of the holes on the tab.
Center the billet grille into the opening of the factory grille shell. Secure the bolt to the threaded holes on the front of the grille. Be sure the bolts are through the OEM grille shell.
Illustration: A close-up image of the billet grille being secured with a bolt and U-clip nut to the factory grille shell.
Secure billet grille using the tabs and nuts from the back side of the OEM grille shell.
Make sure the billet grille is centered and tighten the fasteners, but do not over-tighten.
Reinstall the black plastic cover which was removed in step 2.
Installation completed!!!
Illustration: An image of the completed installation showing the new billet grille on the front of the Ford truck.
The instruction here is for your reference only. You may need to bend the grille a little bit to adjust to fit. We strongly recommend the professional installer for best result. We are not responsible for any damage caused by the installation. Thank you for choosing our product!
