S02 Selfie Stick: Instructions for Use, Features, and Specifications
Model: S02, Manufacturer: TINKSEN INTERNATIONAL
Getting Started and Basic Operation
Power On: Long press the photo button for 3 seconds.
Bluetooth Pairing: The indicator light flashes rapidly for 4 seconds to enter pairing mode. The blue indicator light flashes during pairing. Search for "Selfie" on your mobile phone to connect. The blue indicator light turns off upon successful pairing.
Taking Photos: When the selfie stick is connected to the phone, short press the photo button; the blue light flashes.
Auto Shut-down (No Pairing): After power on, if no pairing connection is made, the device will automatically shut down after 5 minutes of inactivity.
Sleep Mode & Auto Shut-down (Paired): After power on and connection, the device enters sleep mode after 10 minutes of inactivity and shuts down automatically after another 10 minutes.
Power Off: In power-on or sleep mode, long press the photo button for 3 seconds to turn off the device; the indicator light flashes and then turns off.
Features and Modes
Unloading and Loading
Description: The selfie stick can be taken out from and loaded into its holder. To take out, pry it from the groove on the left side.
360° Rotation
Description: The clip rotates 360° for more freedom when taking pictures.
Tripod Mode
Description: To convert the selfie stick into tripod mode, open the handle outwards. It transforms into a tripod. For stability, pull out the last section of the pole and adjust it.
Battery Replacement
Description: To replace the battery, open the remote control cover by prying it from the groove on the left side. The device uses a CR1632 (replaceable) battery.
Specifications
- Material: Stainless Steel + ABS
- Total Length: 1030mm
- Folded Length: 194mm
- Product Weight: 155g
- Battery: CR1632 (replaceable)
- Battery Warning: The battery must not be exposed to environments like direct sunlight, fire, or similar overheating conditions.
Compatibility
- Mobile Operating Systems: Compatible with Android 4.2.2 and iOS 5.0 and above.
- Android Device Note: If you have changed the function of your 'Volume Key' in the camera settings, ensure it is set back to default or 'Shutter' for the selfie stick to work correctly.
Compliance Information
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
