Ingenuity DreamSecure 2-in-1 Co-Sleeping Bassinet

Safety Warnings

Bassinet and Bedside Sleeper Modes: Fall Hazard

WARNING: To help prevent falls, do NOT use the product when infant:

• Begins to push up on hands and knees
• Begins to roll over
• Begins to pull up on product sides (approximately 5 months)
• Has reached 15 lb (approx. 7 kg), whichever comes first

Move your child to another sleeping product when your child reaches this stage.

Bedside Sleeper Mode: Entrapment Hazard

WARNING: To prevent death from entrapment, bedside sleeper must be properly secured to adult bed using the attachment system.

• Gap between bedside sleeper and adult bed must be no more than 1/2 inch (13 mm).
• Check tightness before each use by pulling bedside sleeper away from adult bed.
• If gap exceeds 1/2 inch (13 mm), DO NOT use product. Do not fill gap with pillows, blankets, or other items that are suffocation hazards. Re-install and re-tighten straps per instructions and check again.
• To avoid death from infant's neck being caught on the top rail next to the adult bed, the top rail must be no higher than the adult bed mattress.
• This bedside sleeper is designed for use only with adult beds between 18 and 25 inches (45.7 and 63.5 cm) from floor to top of adult mattress.
• Child can become entrapped and die when improvised netting or covers are placed on top of product. Never add such items to confine child in product.

All Modes: Strangulation Hazard

WARNING: Children have STRANGLED when straps become wrapped around their neck.

• ALWAYS unclip and keep straps away from children when using in bassinet and crib modes to avoid loose hanging straps.
• Strings can cause strangulation! Never place items with a string around child's neck, such as hood strings or pacifier cords.
• Never suspend strings over product or attach strings to toys.
• Never place near a window or door where cords from blinds or drapes can strangle a child.
• Always completely raise the drop side when not attached to the adult bed.
• If a sheet is used with the mattress, only use one specifically designed to fit this mattress. Do not use a sheet designed to fit a full-size crib.
• Prevent possible strangulation or entanglement. Never use bassinet sheet unless it fits securely on bassinet mattress.
• NEVER use plastic shipping bags or other plastic film as mattress covers not sold and intended for that purpose. They can cause suffocation.
• Ensure height adjustment on each side is set to the same position. The mattress MUST NOT be inclined.
• Possible entanglement or strangulation injury. Remove canopy when baby begins to push up on hands and knees. Recommended use from birth to 5 months.
• When child is able to pull to standing position, ensure product is in crib mode and remove bumper pads, large toys, and other objects that could serve as steps for climbing out.
• Always provide the supervision necessary for the continued safety of your child. When used for playing, never leave child unattended.
• Always ensure that the product is properly and completely assembled prior to use.
• Drop side rail must be installed and secured prior to use. Failure to install may result in child falling out of product.
• Product shall not be used without the mattress provided.
• DO NOT use a water mattress with this product.
• Do not move product with child inside.

Choking Hazard

Keep medication and small items that could choke a child away from the playard.

General Safety

• Always place on a horizontal floor.
• Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas fires, etc., in the near vicinity of the product.
• Young children should not be allowed to play unsupervised in the vicinity of this product.
• For indoor use only.

Assembly Instructions

Adult assembly required. Care should be taken in unpacking and assembly. Remove all packaging and fasteners before giving product to child.

Important: Always read and follow assembly instructions for each product use mode (bedside sleeper, bassinet, and crib). Always use ALL required parts for each use mode. Check instruction manual for a list of required parts.

Folding Mechanism

1. Lift the rail opposite the fold button.
2. Slide and squeeze the fold buttons.
3. Lower the rail to fold the frame down and swing the legs inward.
4. Repeat for the other side.

Bedside Sleeper Mode

This bedside sleeper is designed for use only with adult beds that are between 18 and 24.5 inches (45.7 and 62.2 cm) from floor to top of adult mattress.

WARNING: To avoid death from the infant's neck being caught on the top rail on the side that is next to the adult bed, the top rail must be no higher than the adult bed mattress.

Ensure bed frame and mattress are aligned with the sleeper. An acceptable bed frame is one where the frame is in-line with the mattress. Unacceptable is when the bed, mattress, boxspring, and frame are not in-line.

Crib Mode

Assemble the frame using the provided parts. For example, connect parts labeled '1' and '2' (x2 sets) to form the base, and then attach the side rails (parts labeled '3' and '4', x2 sets each).

Always ensure that the product is properly and completely assembled prior to use.

Product Information

Find Ingenuity on Facebook and Instagram @ingenuitybaby.

Visit ingenuitybaby.com for more information.

Ingenuity offers a range of products including: Toys, Activity Gyms, Bouncers, Rockers, Swings, Bassinets, Playards, High chairs, and Booster Seats.