Baby Trend Portable Playard with Bassinet

Model: PY91xxxG

Instruction Manual

Important Safety Instructions

Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.

WARNING: Failure to follow the instructions could result in serious injury or death.

Playard Warnings

Full-Size Bassinet & Cradles Warnings

Parts List

Check that you have all the below parts for this model before assembling the playard.

Assembly Instructions

IMPORTANT! To ensure safe operation of your playard, please follow these instructions carefully. Please keep these instructions for future reference.

IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.

IMPORTANT! Adult assembly is required.

To Assemble Playard

  1. Unzip bag and remove Playard frame (Fig. 1). Undo the Fasten straps and set the Mattress aside. DO NOT push center down yet.
  2. Erect the top rails. Pull up one rail at a time, hold one hand on each side of the rail and pull up sharply. Do not pull from the middle where the center latch release is located. Make sure both tubes latch in place and each rail is rigid (Fig. 2).

    IMPORTANT: The handle located in the center of the Playard floor MUST remain raised (Approx. 45.7 cm or 18 inches) while locking the side rails in place. If the center is not raised, the rails will NOT lock. If you experience difficulty and one side of the rail will lock but the other side will not, then unlock the rail by squeezing the release in the center and try again. If you still have difficulty, contact our Customer Service Center.

  3. Once all four (4) top rails are locked in place, push down on the center handle (Fig. 3a). The center mechanism will automatically lock in place.

    IMPORTANT: Test each top rail by pushing down slightly to confirm each is rigid and securely in place before use (Fig. 3b).

  4. Place the Mattress on the floor of the Playard with the padded side facing up (Fig. 4).
  5. Insert hook and loop fasteners located on the underside of the Mattress through the slots in the floor of each end of the Playard (Fig. 5a). Fasten the hook and loop straps to the underside of the Playard floor to prevent the Mattress from moving (Fig. 5b).
  6. Use the wheels to make moving the playard easier. May require slight lifting of the frame from the opposite end (Fig. 6).

Folding Playard

  1. Release the hook and loop fasteners holding the Mattress from underneath the Playard floor or the Bassinet and set the mattress aside.
  2. Do not unlock top rails yet; the center of the floor must be raised before top rails will unlock.
  3. Rotate the center handle counter-clockwise 90 degrees and raise the center as high as the top rails (Fig. 7). Gather the Legs and Wheels together towards the center as close as possible so that they nearly touch.
  4. Locate the rail latch release in the center and bottom side of each rail. Squeeze the lever with two hands until the rail releases the two tubes (Fig. 8a), then push down (Fig. 8b).

    NOTE: If the top rail(s) do not release completely, DO NOT FORCE! Lift the center of floor higher. Both tubes must be released for the top rail to fold.

  5. Gather four (4) corners and center all together tightly (Fig. 9). Wrap Mattress around Playard frame with padded side facing inward.
  6. Secure the hooks and loop straps by feeding them through the loops on the end of the Mattress and folding them back onto themselves (Fig. 10).
  7. Place folded Playard into carry bag so that the handle comes through the opening between each side of the zipper.

To Assemble Full-Size Bassinet

ATTENTION: Playard must be fully assembled and securely locked before installing or using the Full-size bassinet feature. (See To Assemble Playard section). You will need to remove the mattress from the bottom of the Playard to use inside your Full-size bassinet.

  1. Connect opposing Mattress Support Tubes that are attached to the bottom of the Bassinet (Fig. 11a).

    NOTE: Before placing the Mattress into the Bassinet, make sure Mattress Support tubes are connected as seen in (Fig. 11b).

  2. Position the full-size bassinet over onto the assembled Playard. Secure in place by pushing down firmly on each plastic support clip until all are snapped into place (Fig. 12).
  3. Place the Mattress into the full-size bassinet with the padded side facing upward (Fig. 13).

To Remove Full-Size Bassinet

Maintenance and Cleaning Instructions

Warranty

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.

The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.

Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

Baby Trend Customer Service

The Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.

PDF preview unavailable. Download the PDF instead.

PY91xxxG 2L 041822.1 HB Adobe PDF Library 16.0.7 Adobe InDesign 17.2 (Macintosh)

Related Documents

PreviewBaby Trend Nursery Center Playard Assembly and Safety Manual
Comprehensive instruction manual for the Baby Trend Nursery Center playard (Model PY81958), including assembly steps, safety warnings, maintenance, and accessory installation.
PreviewBaby Trend Nursery Center Playard Assembly and Safety Guide
Comprehensive instructions for assembling and safely using the Baby Trend Nursery Center playard (Model PY81999). Includes parts list, safety warnings, assembly steps for playard, bassinet, changing table, and mobile, plus maintenance and customer support information.
PreviewBaby Trend Nursery Center Playard PY81833 Instruction Manual
Comprehensive instruction manual for the Baby Trend Nursery Center Playard (Model PY81833), covering assembly, safety warnings, parts list, and maintenance. Learn how to safely set up and use your Baby Trend playard.
PreviewBaby Trend Nursery Center Playard Assembly and Safety Manual
Comprehensive assembly instructions, safety warnings, and maintenance guide for the Baby Trend Nursery Center Playard (Model PY81105). Includes step-by-step assembly, parts list, and important safety precautions for safe use.
PreviewBaby Trend Resort Elite Nursery Center Playard Instruction Manual
Comprehensive instruction manual for the Baby Trend Resort Elite Nursery Center Playard, covering assembly, safety warnings, parts, operation, and warranty information. Includes detailed steps for setup, use, and maintenance.
PreviewBaby Trend Nursery Den Playard with Oval Napper - Instruction Manual
This document provides comprehensive instructions for assembling, using, and maintaining the Baby Trend Nursery Den Playard with Oval Napper. It includes detailed safety warnings, accessory instructions for the bassinet, changing table, and oval napper, as well as warranty information and customer service contact details.
PreviewBaby Trend Nursery Center Instruction Manual PY87119
Comprehensive instruction manual for the Baby Trend Nursery Center (Model PY87119), covering assembly, safety guidelines, and product features for infant use. Includes multilingual instructions.
PreviewBaby Trend Nursery Center Playard Instruction Manual
Instruction manual for the Baby Trend Nursery Center Playard (Model PY81XXX/XXXA), detailing safety warnings, parts identification, assembly steps, maintenance, and warranty information.