Installation Guide for TradeTools models including: CB1 Direct Box, CB1, Direct Box, Box

user manual

ProCo Sound Audio Interface Products

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 1 Pages, 88.62KB

SIGNAL SOURCE
ELECTRIC GUITAR or BASS KEYBOARD

CB1 DIRECT BOX

MIC INPUT OF MIXING CONSOLE

APPLICATION INFORMATION
STAGE OR STUDIO AMPLIFICATION
(IF USED)
MIXER

XLR FEMALE

GND LIFT LO-Z OUTPUT

AMPLIFIER PREAMP MIXER DRUM MACHINE

SIGNAL PATH MICROPHONE CABLE (Balanced) INSTRUMENT CABLE (Unbalanced)

CB-1
DIRECT BOX

INPUT OUTPUT

1/4" (6.3mm) PHONE PLUG

1/4" (6.3mm) PHONE PLUG

INSTRUMENT AMPLIFIER PREAMP
POWER AMP

CONTROLS:
INPUT: 1/4" (6.3mm) phone jack accepts unbalanced signals from instrument or other source. Input impedance-greater than 180 kohm. Handles signals of up to +20 dBv at 20 Hz. NOT RECOMMENDED FOR SPEAKER LEVEL USE.
OUTPUT: 1/4" (6.3mm) phone jack provides "loop-through" (parallel) connection from input jack. Used when inserting CB-1 between instrument and amplier.

LO-Z OUTPUT: Male 3-pin XLR-type connector provides balanced oating low-impedance output (pin 2 hot). Connect to mixing board microphone channel input. Recommended load impedance: 1.0 kohm.
GND/LIFT: GND position connects INPUT and LO-Z OUTPUT grounds together. LIFT position "oats" LO-Z OUTPUT. Used to reduce hum and buzz by eliminating ground loops and providing proper grounding for various conditions.

Pro Co Sound 225 Parsons Street | Kalamazoo, MI 49007 800-253-7360

» www.procosound.com



References

• ProCo Sound