Elemara Children's Toy UTV

About Your New Ride-On

The owner's manual contains important safety information as well as assembly, use and maintenance instructions. The Ride On UTV must be assembled by an adult who has read and understands the instructions in this manual.

• Keep the package away from children and dispose of properly before use.
• Keep this manual for future reference.
• Made in China.

On the purchase of your new Ride On UTV, this Ride On UTV will provide your child with many miles of riding enjoyment. To help assure you and your rider a safe ride, please read this manual carefully, and keep it for future reference. Follow the recommendations in this manual; they are designed to improve the safety and operation of your Ride On UTV and its rider.

WARNING: Safety Hazards

The following safety hazards may result in serious injury or death:

• Never leave a child unattended.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair, and clothes away from moving parts.
• Always wear shoes when operating this vehicle.
• Maximum of two children are allowed in the vehicle at a time.
• Children under 3 years of age cannot use the vehicle.
• Only drive on level ground.
• Do not go near swimming pools or other bodies of water, drop-offs, or up and down steep inclines.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel, or on wet surfaces.
• Do not drive the vehicle on streets or near cars.
• Protective equipment should be worn. Not to be used in traffic.
• The toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.
• To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never allow more than 2 riders.
• ADULT ASSEMBLY REQUIRED
• Not to be used in traffic
• CHOKING HAZARD-Small parts. Not for children under 3yrs.

Safety Notes

NOTE: For best performance, only use this vehicle on flat and hard surfaces.

Age Range: 37-96 months

WEIGHT CAPACITY: 59KG is the maximum weight for 2 riders (combined)

CHOKING HAZARD - Small parts. Not suitable for children under 36 months. The product contains small parts, keep children away when assembling. Make sure to remove all packaging material and parts from underneath the vehicle body.

• Never open the battery. Batteries contain lead and lead compounds (acids).
• Limbs, hair, and clothing can get caught in moving parts. Always wear shoes, keep limbs away from moving parts, and do not wear loose clothing while operating this vehicle.
• This vehicle does not have brakes or braking capability. Do not leave a child unattended during operation. Do not use this in a location that may require braking capability, as this could result in loss of control, which may cause serious injury or death.
• Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night, or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand, or gravel may result in an unexpected accident such as tipping over, and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:
  • Pulling the vehicle with another vehicle or similar device
  • Allowing more than two children to ride
  • Pushing the user
  • Traveling at an unsafe speed

Battery Warnings

The following safety hazards may result in serious injury or death:

• Use only battery(ies) and charger specified by the manufacturer. Using another battery or charger may cause a fire or explosion.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire, or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not charge the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact between the terminals. Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If contact or exposure occurs, immediately call your physician. If the chemical is on the skin or in the eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds (acid).
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep the charger housing closed.

Technical Specs

• Construction Material: PP/Iron
• Motor: 12V/45W
• Speed: 1.875mph-3.728mph (3-6km/h)
• Weight Capacity: 130lbs
• Charger: 12V 1000mA
• Battery Type: 12V 10Ah
• Recommended for Ages: 37-96 months
• Use Time: 30-60 minutes
• Charging Time: 8-12 hrs
• Remote Control Battery Operated, Requires (2) x 'AAA' Batteries
• Remote Control Battery Type: alkaline battery
• Battery Life: Up to 2+ Hours
• Dimension: 48.2" x 30.9" x 31.5" inches

Tools Required

• SCREWDRIVER (BRING YOUR OWN)
• M10 WRENCH (PROVIDED)
• M10 IRON WRENCH (PROVIDED)
• 2 PERSON ASSEMBLY
• Approximately 45min ASSEMBLY

Hardware

1. M4*12mm SCREW (2 PCS)

2. φ12 WASHER (6 PCS)

3. M10 NUTS (4 PCS)

4. COTTER PIN (2 PCS)

5. φ8 GASKET (2 PCS)

6. SCREW (2 PCS)

7. φ10 WASHER (2 PCS)

8. BEARING (2 PCS)

Parts

• B REAR WHEEL (4 PCS)
• C WHEEL COVER (4 PCS)
• D STEERING WHEEL (1 PCS)
• E FRONT BLOCK (1 PCS)
• F SEARCHLIGHT (1 PCS)
• G SEAT (1 SET)
• H REAR BUMPER DECORATION (4 PCS)
• J GEAR BOX (L/R) (2 PCS)
• K REMOTE CONTROL (1 PCS)
• L CHARGERS (1 PCS)
• M FRONT BRACKET ASSEMBLY (OPTIONAL) (4 PCS)
• N REAR AXLE (1 PCS)
• O TORSION BAR (2 PCS)

Product Assembly

Fix the front bracket assembly. (M ⑧)

• Insert the bearing into the front bracket assembly.
• Insert the front bracket assembly into the body square tube.

As shown in the figure: Connect the motor wires.

Fix the dual drive front bracket. (3 ⑦)

• In turn, put the φ10 washer and nut into the dual drive front bracket.
• Fix the nut with the M10 iron wrench.

Fix the torsion bar (4 ⑤ ⑥)

• Turn the torsion bar so that the hole of the torsion is aligned with the hole of the rear axle fixing seat, and then insert the screw.
• Place the φ8 gasket on the screw and insert the cotter pin into the screw hole for fixing. (Install the other side in the same way)

Fix the rear bumper decoration. (H)

• Clip the rear bumper decoration into the body slot.

Fix the rear axle. (N)

• Clip the rear axle into the body slot.

Fix the gear box (L/R). (J)

• Put the gear box into the rear axle, and stuck the motor into the body slot.
• Thread the transmission wire into the body hole to the battery compartment. (Tips: gear box left right distinction)

Put the rear wheel, φ12 washer and nut into the front axle in turn. Fix the nut with the M10 wrench and then attach the wheel cover to the rear wheel.

Place the gear box, rear wheel, φ12 washer, and nut on the rear axle in turn. Fix the nut with the M10 wrench and then attach the wheel cover to the rear wheel.

Put the car upside down.

Find the main power cord under the seat, and insert the plug of the power cord into the corresponding socket of the receiver. The plug of the drive motor cable is docked with the plug on the receiver (the plug on the receiver is not differentiated left and right).

Fix the steering wheel. (D)

• Remove the nut and bolt from the steering wheel.
• Connect the wires coming from the steering column to the wires on the steering wheel.
• Insert the steering wheel over the steering and secure with nut and bolt.

Fix the seat. (G)

• Insert the lower seat cover into the upper seat cover.
• Stuck the seat buckle into the vehicle slot.
• Fix with screws.

Install Searchlight Battery

Use a screwdriver to remove the searchlight battery cover screws and install them in sequence.

• Put the battery into the battery card slot after distinguishing the positive and negative poles.
• Cover the battery cover and fix it with screws.
• Power switch: (-) = on, (0) = off.

Fix the searchlight. (F)

• Stuck the searchlight into the corresponding slot on the body.

Fix the front block. (E)

• Stuck the front block into the corresponding slot on the body.

As shown in the figure: Secure the net bag to the searchlight the Velcro on the net bag.

Dashboard Diagram

1. Pedal button: Step on the button, the car will move; when release, the car will slowly stop.

2. Shift Switch: Change the direction of the car, Forward-Backward.

3. Horn button: press to play the horn.

4. No function.

5. Control board

6. Power display: clearly see the battery power and help judge whether the battery needs to be charged.

7. U

8. M

9. Socket: charge.

10. Power button: Long Press it 3 seconds, Turn the vehicle on and off.

11. Last song/volume-: press it to switch to the last song and long press can decrease volume.

12. Pause button: press it to pause music;

13. Next song/volume+: press it to switch to the next song and long press can increase volume.

14. Wireless Technology: After connecting your mobile phone and the wireless device, the car can play music from your mobile phone.

15. F: Radio, long press it 2-3 seconds, Automatic search.

16. Music Button: press it to play music.

17. High speed button: press it to change the car to the high-speed movement.

18. Low speed button: press it to change the car to the low-speed movement.

19. Light button: press it to switch the light.

Remote Control Operation

WARNING: Only used by adults.

The remote control is not a toy. It is for adult use only, and should not be used by a child. Close adult supervision is always required. Reception range may change significantly with weather, battery, and other environmental conditions.

Remote control first. When the remote control is on, foot pedal is not workable.

Operation Manual:

Take out the remote control. Open the battery compartment on the back of the remote control and add two AAA LR03 alkaline batteries. Pay attention to the polarity of the batteries. When the alignment light and speed indicator light up, it indicates that the battery installed is correct. This product does not provide dry batteries.

Button Description:

• (1) Long press on the frequency key (M) 2-4 seconds, Low speed LED light flashing. Turn on the power of the car, Low speed LED light keep flashing to long lighting, then frequency bind succeed. If the frequency bind failed (Low speed LED light flashing), remove the battery and repeat steps.
• P: Press to brake
• S: Speed: press to change speed (low, middle, and high speed).
• Forward
• Backward
• Turn Left
• Turn Right

Note: Without operation after 10 seconds, indication light will off into power saving mode.

Charging Instructions

WARNING: Only an adult who has read and understood the safety warnings should handle, charge and recharge the battery.

• Insert the charger jack into the charging hole of the car.
• Plug the charger plug into the stable matching AC power supply as shown in the picture.

Charging and Battery Care

• Charge the battery for 4-6 hours before you use your vehicle for the first time.
• On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty.
• Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to drain completely.
• Check the battery and charger (supply cord, connector) for wear and damage before charging. DO not charge the battery if damage has occurred.

Caring For Your Ride-on

• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap.
• Charge battery at least once a month to prolong the life of the battery.

Warnings Regarding Batteries

IMPORTANT

• You must charge your battery for 4-6 hours before you use your vehicle for the first time.
• Always charge battery for a full 10hrs after each use.
• Charge the battery once a month, even if you are not using your vehicle.

The battery on the vehicle is not replaceable.

• DO not mix old and new batteries.
• DO not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged by adults.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.
• Only use the battery specified by the manufacturer.
• Only use the charger specified by the manufacturer.

Troubleshooting

Completely read through this manual and the troubleshooting guide table before calling. If you still need help resolving the problem, contact Elemara.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Questions? Comments?

We are here to help!

Email: officalcssupport@elemara.us