Horizontal Louvered Wall Assembly Instructions

Horizontal Privacy Panel

Please read the following instructions completely before you begin assembly. Any errors made during installation are not covered by the product's warranty. If you have any questions during the installation process, please contact COMFOLA customer support.

Necessary Tools and Safety Gear (Not Supplied)

• Goggles & Gloves ??
• Ladder ?
• Pistol drill ड्रिल
• Spirit level ?
• Utility knife ?
• Helmet ⛑️
• Tape measure ?
• Monkey wrench ?

2D&3D Footing Measurement

The Horizontal Louvered Wall is available in two sizes:

• Panel 1: 36.6 inches (3.3 ft) width, 91.9 inches height.
• Panel 2: 48.6 inches (4.3 ft) width, 91.9 inches height.

Carton Contents

Assembly Steps

Step 1

Attach two horizontal support bars (H1) to the ends of two long louvered panels (M1, M2).

Visual shows H1 bars positioned at the top and bottom of M1 and M2 panels.

Step 2

Insert a connector piece (E1) between the two long panels (M1, M2) and secure it at the designated screw positions.

Visual shows E1 connecting M1 and M2, with a close-up indicating screw positions.

Step 3

Secure the structure using screws W1 and W5 at the indicated positions.

Visual shows screws W1 and W5 being used to fasten components.

Step 4

Attach short frame pieces (N1, N2) to the ends of the long panels (M1, M2) using screws W1 and W5.

Visual shows N1 and N2 forming the frame, secured by W1 and W5.

Step 5

Attach additional frame pieces (N2) and secure with screws (W2).

Visual shows N2 being attached and secured with W2.

Step 6

Attach horizontal support bars (H1) to the assembled frame structure using screws (W2).

Visual shows H1 bars being attached to the frame, secured by W2.

Step 7

Attach the bracket/connector (K1) to the corner of the structure, aligning it as shown.

Visual shows K1 being attached to the corner of the assembled structure, with an "Align" indicator.

Step 8

Secure the structure using screws (W2) at the indicated points.

Visual shows W2 being used for final securing.

Step 9

Attach panels using screws W1 and W5 at the indicated positions.

Visuals show W1 and W5 being used to attach panels.

Step 10

Secure components using screws W4, W6, and W3 at the indicated positions.

Visuals show W4, W6, and W3 being used for fastening.

Step 11

Insert clips (E2) into the designated slots to secure the louvered panels. The action is indicated by [Press].

Visuals show E2 clips being inserted into slots, with a close-up indicating "Stuck In Sponge" for proper fit.