Nokia Go Earbuds+ TWS-201 Quick Start Guide

Getting Started

Before using Nokia Go Earbuds+, remove the protective film from the earbuds and place them back in the charging case. Connect the USB Type-C cable to a power source to begin charging. Fully charge the earbuds and the charging case before first use.

For optimal fit and listening performance, replace the silicone ear tips with the size that best suits you.

Pair and Connect with Bluetooth

Pairing with the device

Turning on and pairing: When you take the earbuds out of the charging case, they will turn on and pair with each other automatically. After successful pairing, the LED indicator on the right earbud will flash blue and red alternately, indicating they are ready to connect to your Bluetooth device.

Connecting to your Bluetooth device: Enable Bluetooth on your device and select "Nokia Go Earbuds+" from the Bluetooth menu to connect. During the connection process, the LED indicator on the right earbud will flash blue and red alternately. The earbud LEDs will show a blue light every 10 seconds upon successful Bluetooth connection.

After the initial connection, the earbuds will automatically connect to your paired Bluetooth device whenever taken out of the charging case.

The earbuds will automatically turn off if there is no Bluetooth connection for 5 minutes.

Additional Controls

Using a single earbud:

You can use either the left or right earbud as a mono headset after the initial pairing.

Reset to original settings:

In the earbud pairing mode, press and hold the touch bar on both earbuds simultaneously for 5 seconds until the LED flashes blue and red 3 times, then turns off. The reset is successful.

Product and Safety Information

Remote control functions may vary depending on the application and device model. Sound column instructions do not respond to iOS devices. Since devices with Bluetooth wireless communication technology communicate by radio waves, they do not need to be in direct line of sight. However, Bluetooth devices must be within 10 meters (33 feet) of each other, though the connection may be subject to interference from obstacles such as walls or other electronic devices.

For your safety

Important: Read these simple instructions. Failure to follow these instructions could be dangerous or violate local laws and regulations. For more information, read the user guide in its entirety.

Turn off in restricted areas

Turn off your device if the use of a Bluetooth headset is prohibited or if it can cause interference or hazards, for example, on airplanes, in hospitals or near medical devices, or near areas with fuel, chemicals, or explosive hazards. Comply with all instructions in restricted areas.

Batteries, Chargers, and Other Accessories

Use only batteries, chargers, and other accessories approved by HMD Global Oy for use with this device. Do not connect incompatible products.

Protect your hearing

To prevent hearing damage, avoid listening at high volumes for extended periods.

Hearing

Warning: When using the headset, your ability to hear outside sounds may be reduced. Do not use the headset if it may endanger your safety.

Small children

Your device and its accessories are not toys. They may contain small parts. Keep them out of reach of small children.

Device Maintenance

Handle your device with care. Following these suggestions will help keep your device in working order:

• Keep the device dry. Rain, humidity, and all types of liquids or moisture may contain mineral substances that corrode electronic circuits.
• Do not use or store the device in dirty or dusty areas.
• Do not store the device in high temperatures. High temperatures can damage the device or battery.
• Do not store the device in low temperatures. When the device returns to its normal temperature, moisture may form inside it and cause damage.
• Do not open the device other than as instructed in the user guide.
• Do not drop, strike, or shake the device or battery. Rough handling can damage the device.
• Use only a soft, clean, dry cloth to clean the device surface.
• Do not paint the device. Paint may prevent proper operation.