KUNGSFORS Dish Drainer
Safety Warning
⚠️ WARNING! Serious or fatal crushing injuries can occur from furniture falling down. To prevent this, use the provided wall attachment device(s). Wall screws and plugs are not included; use suitable ones for your walls and intended load. Seek professional advice if uncertain. Follow instructions carefully.
Hebrew: Furniture falling can cause severe injury. Secure to the wall with included fixing devices. Fixing screws not included; match wall material. Use appropriate fixings. Professional advice recommended. Follow instructions carefully.
Parts Included
- 4x Screw (Part No. 115294)
- 4x Washer/Nut (Part No. 114418)
- 1x Bracket (Part No. 158580)
Note: Wall mounting brackets are required but not detailed in this parts list.
Assembly
Step 1: Prepare Base
Place base unit on a flat surface. Secure with 4x screws (115294) and 4x washers/nuts (114418). [Tools shown: screwdriver, level]. Attach 1x bracket (158580) to the underside of the base unit.
Diagrams show correct assembly methods, including using tools and proper placement.
Step 2: Attach Brackets to Base
Use 3x screws (115294) to firmly attach brackets to the base unit.
Step 3: Mount to Wall
Position the assembled unit and slide it onto wall-mounted support brackets. [Diagram shows sliding unit onto wall rails with directional arrows].
Step 4: Secure Unit
Secure the unit to wall brackets with 1x screw (115294) for stability. [Diagram shows securing with a screw].
Step 5: Final Placement
The dish drainer is now in its final position. [Diagram shows final positioning with a directional arrow].
Multiple Units
Connect multiple KUNGSFORS units side-by-side. Indicators: [compatible] ('O') and [incompatible] ('X') guide correct arrangement.
