Global Industrial™ Portable Air Conditioner with Heat

Introduction

This manual provides essential information for the safe installation, operation, and maintenance of your Global Industrial™ Portable Air Conditioner with Heat, Model 293136. Please read this manual thoroughly before using the unit.

Safety Precautions

• Read all instructions before use.
• Ensure the unit is connected to a properly grounded electrical outlet.
• Do not operate the unit with a damaged cord or plug.
• Keep the power cord away from heated surfaces.
• Do not immerse the unit, cord, or plug in water or other liquids.
• Allow at least 1 foot (30 cm) of clearance around the unit for proper ventilation.
• Do not block air intake or exhaust vents.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, unless supervised.
• Children should be supervised to ensure they do not play with the appliance.
• Always unplug the unit before cleaning or performing maintenance.
• Dispose of water collected in the unit according to local regulations.

Installation

Proper installation is crucial for efficient operation. The following describes typical installation steps:

1. Unit Placement

Place the unit on a flat, stable surface, away from direct sunlight and heat sources. Ensure adequate clearance (at least 12 inches / 30 cm) around the unit for airflow.

2. Exhaust Hose Setup

Connect the exhaust hose to the rear of the unit. Extend the hose to a suitable window or vent. The unit requires continuous ventilation to expel hot air.

Diagram Description: The rear of the unit shows an exhaust port where the flexible hose attaches. The hose is designed to direct hot air outside.

3. Window Kit Installation

Assemble the adjustable window slider panel and insert it into the window opening. Attach the exhaust hose connector to the panel. Ensure the window is sealed to prevent air leakage.

Diagram Description: A window slider panel is shown fitted into a standard window frame. The exhaust hose is connected to an opening in this panel, directing air outwards. The panel is designed to seal the remaining window space.

4. Power Connection

Plug the unit into a grounded 115V electrical outlet.

Operation

The unit can be operated using the control panel on the unit or the included remote control.

Control Panel Functions

• Power Button (▶️): Turns the unit on or off.
• Mode Button: Selects operating mode: Cool, Heat, Fan, Dehumidify.
• Fan Speed Button: Adjusts fan speed: Low, Medium, High.
• Timer Button: Sets a timer for automatic shut-off or start-up.
• Temperature Up/Down Buttons: Adjusts the desired temperature setting.

Diagram Description: The front panel features a digital display showing the current temperature and mode. Clearly labeled buttons allow for mode selection, fan speed adjustment, timer setting, and temperature control.

Remote Control Functions

The remote control mirrors the functions of the control panel, allowing for convenient operation from a distance.

Maintenance and Cleaning

• Air Filter: Clean the air filter regularly (e.g., every two weeks) to maintain efficiency. Slide out the filter, wash it with mild soap and water, rinse, and dry completely before reinserting.
• Exterior: Wipe the exterior surfaces with a soft, damp cloth. Do not use abrasive cleaners.
• Water Drainage: The unit may collect condensation. Periodically check the water tank or drainage port. If the tank is full, unplug the unit and drain the water safely. Some models may have a continuous drain option.

Diagram Description: A diagram shows how to access and remove the air filter from the side or back of the unit for cleaning.

Troubleshooting

Specifications

Note: Specifications are subject to change without notice.

Additional Information

For Wi-Fi setup and advanced features, please refer to the dedicated Wi-Fi setup guide or the manufacturer's website.

Diagram Description: A generic icon representing Wi-Fi connectivity (e.g., radiating waves) is shown next to the Wi-Fi enabled feature.