Vogue L793 Chef's Blow Torch Instructions

1. Gas Refilling

• Prior to filling with butane, make sure the gas refill valve is tight.
• Use only high quality butane gas.
• Shake gas container a few times to warm fuel up.
• Insert the container nozzle vertically down into the gas refill valve. (See Figure 1)
• Use a pumping action when refilling. If any liquid gas sprays out, the torch is full. DO NOT over-fill to avoid blockage.
• After fuelling, allow a few minutes for gas to stabilize.

Figure 1: Illustration showing how to insert a butane gas canister nozzle into the torch's refill valve.

2. Lighting

• Turn the adjustment knob counter-clockwise for about 2/3 of a circle.
• The gas will blow out with a "hiss" from the burner nozzle. (See Figure 2)
• Press the "ignition button". The flame will ignite instantly. (See Figure 3)

Figure 2: Illustration showing the adjustment knob being turned counter-clockwise to release gas, indicated by an "ON" label.

Figure 3: Illustration showing the ignition button being pressed to light the torch.

Troubleshooting Ignition: If the adjustment knob is in the ignition position and gas is escaping from the burner nozzle, but the flame does not light when pressing the ignition button, adjust the position of the air control sleeve by aligning the small hole on the sleeve with the hole on the connecting tube.

3. Temperature Adjustment

• Adjust the flame of the torch to approximately 10-25mm (1/2 to 1") in length when in use. Do not set the flame too long, as it will waste gas.
• Turn the "air control sleeve" either to the right to reduce the temperature or keep it in the left for maintaining the temperature.

4. Turning Off

• Turn the adjustment knob fully clockwise to extinguish the flame. (See Figure 4)

Figure 4: Illustration showing the adjustment knob being turned clockwise to extinguish the flame, indicated by an "OFF" label.

5. Warnings

• Do not touch the flame guard when hot!
• Keep out of reach of children.
• Butane gas is extremely flammable. Please handle with care.
• Always point away from eyes and body when igniting or operating.
• Do not store under direct sunlight or in anywhere that will exceed 40 °C (104 °F).
• Make sure the "adjustment knob" is firmly closed and the flame is completely extinguished after use.
• Do not continuously use this tool for longer than one hour.
• After use, let the tool cool down before storage.
• Never puncture or put in fire.
• To use only in well-ventilated areas.

Product Diagram

The blow torch consists of the following parts:

• Flame guard
• Ignition pin
• Air control sleeve
• Stand base
• Adjustment knob
• Ignition button
• Gas tank
• Filling valve