HyperGear True Wireless Earbuds

User Manual

Important Safety Instructions

Do not store the device in a depleted state. Battery cells may be damaged. Charge your unit at least once every 3 months even when not in use.
Always store the earbuds in the case when not in use.
Permanent hearing loss may occur if you listen at high volumes. Set the volume to a safe level.
Do not store at extreme temperatures (below 40° F or above 90°F).
Recharge your device with the included Micro USB charging cable or a certified 3rd party cable and a 2A charging adapter. Standard cables and adapters may charge the battery too slowly and damage/overheat the battery or cause a fire hazard.
Do not attempt to modify, disassemble, or repair this product.
Avoid excessive drops, bumps, and abrasions.
If the device has dents, punctures, tears, deformities, or corrosion, discontinue use and contact the manufacturer or dispose of in an appropriate method.
If you find this product rapidly increasing in temperature, emitting odor, deformed, abraded, or demonstrating an abnormal phenomenon, discontinue use immediately.
Unit is not waterproof. Do not submerge or expose to corrosive materials. Do not clean with harsh chemicals, soaps or detergents.
Disposal of the unit in the garbage is unlawful under state and federal environmental laws and regulations.

Warranty Information

Limited One Year Warranty

Contact info@myhypergear.com to submit a warranty claim. Proof of purchase is required.

Getting Started

Power On

Option 1: Remove the earbuds from the charging case. They will automatically turn on.

Option 2: Press the MFB on BOTH earbuds at the same time for 4 seconds. They will turn on automatically.

Power Off

Option 1: Place the earbuds in the charging case and close the lid. They will automatically turn off.

Option 2: Press the MFB on BOTH earbuds at the same time for 4 seconds. They will turn off automatically.

Charge the Earbuds

Place the earbuds in the charging case. Press the power button on the case to turn the charger ON.

The case LED will turn BLUE while charging and turn off when complete (approximately 1 hour).

How to Pair

1. Remove the earbuds from the charging case.

2. They will turn on and pair with each other automatically.

3. Wait for the RIGHT (R) earbud to flash RED & BLUE. Activate the Bluetooth feature on your device (phone, tablet, etc.) and select "HyperGear True Wireless" to connect and pair.

NOTE: If your device prompts for a PIN code, enter "0000".

5. You will hear a tone confirming the successful connection.

NOTE: The earbuds will automatically reconnect to the last paired Bluetooth audio device when the unit is turned on.

(Diagram description: Visual guide showing earbuds removed from case, pairing with each other, right earbud flashing red/blue, and connecting to a phone via Bluetooth.)

Twist to Secure

(Diagram description: Illustration demonstrating a twisting motion to ensure a secure fit of the earbud in the ear.)

Controls

Multifunction Controls

Play/Pause: Press 1x
Answer/End Call: Press 1x
Reject Call: Press & Hold (3 sec)
Redial Last Number: Press 2x

Track Control

(L) Left Earbud:

Previous Track: Long Press (2 sec)

(R) Right Earbud:

Next Track: Long Press (2 sec)

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

	HyperGear Fabrix Mini Wireless Speaker User Manual & Safety Guide Comprehensive user manual and safety guide for the HyperGear Fabrix Mini Wireless Speaker. Learn about setup, operation, Bluetooth pairing, charging, and FCC compliance. Model: 2AQ5C-FABRIX.
	HyperGear SleepEEZ Mini Noise-Blocking True Wireless Earbuds Discover HyperGear SleepEEZ, the mini noise-blocking true wireless earbuds designed for ultimate comfort and improved sleep. Featuring passive noise-blocking, long playtime, and a secure fit for side sleepers.
	HyperGear Vibe Wireless Headphones User Manual User manual for the HyperGear Vibe Wireless Headphones, covering specifications, charging, pairing, usage via AUX, functions, and important safety instructions.
	HyperGear SoundTower Wireless LED Speaker User Manual Comprehensive user manual for the HyperGear SoundTower Wireless LED Speaker, covering safety instructions, specifications, pairing, audio modes, and party mode.
	HyperGear ChargePadPro Wireless Charger User Manual & Safety Guide User manual for the HyperGear ChargePadPro wireless charger (Model HYP15WPSM). Includes essential safety warnings, product components, usage instructions, LED status indicators, important notes, FCC compliance information, and warranty details.
	HyperGear Activ8 Smartwatch + Fitness Tracker User Manual User manual for the HyperGear Activ8 Smartwatch and Fitness Tracker, covering setup, controls, specifications, and safety instructions.
	HyperGear Active True Wireless Earbuds FCC Test Report This FCC test report details the compliance of the HyperGear Active True Wireless Earbuds (Model 14316) manufactured by Shenzhen Linpa Technology Co.,Ltd, tested by Shenzhen LCS Compliance Testing Laboratory Ltd. It covers tests performed according to FCC CFR 47 Part 15 Subpart C.
	HyperGear Wireless Earbuds and Headphones User Manual Comprehensive user manual for HyperGear wireless earbuds and on-ear headphones, covering setup, operation, troubleshooting, and safety information.