ULINE WindPro® Heavy Duty Snap Edge Sign

Tool Included

Wrench [?]

Parts

• Frame x 1
• Base x 1
• Two-holed Washer x 2 (Ships with base)
• Nut x 4 (Ships attached to frame)

Assembly Instructions

Note: Remove washers and nuts before assembling the sign.

1. Insert screws on the bottom of the frame through the top of the base.

   [Diagram Description: Shows screws being inserted from the underside of the frame into the top surface of the base. (See Figure 1)]

2. Place two-holed washers onto the screws at the bottom of the base.

   [Diagram Description: Illustrates placing two-holed washers onto the screws that protrude from the bottom of the base. (See Figure 2)]

3. Slide nuts onto the screws on the bottom of the base.

   [Diagram Description: Depicts sliding nuts onto the screws from the underside of the base. (See Figure 3)]

4. Use the wrench to tighten the nuts around the screws until snug against the washers.

   [Diagram Description: Shows a wrench being used to tighten the nuts against the washers, securing the frame to the base. (See Figure 4)]

   CAUTION! Tighten carefully. Overtightening may cause the base to crack. [⚠️]

Sign Insertion Instructions

1. Flip open the snap edges of the sign frame.

   [Diagram Description: Shows hands opening the flexible snap edges of the sign frame, preparing it for sign insertion. (See Figure 5)]

2. Remove the plastic cover.

   [Diagram Description: Illustrates hands peeling away a protective plastic cover from the inside of the sign frame. (See Figure 6)]

3. Insert the sign.

4. Replace the plastic cover to protect the sign.

   [Diagram Description: The protective plastic cover is being placed back into the frame over the inserted sign. (See Figure 7)]

5. Flip the snap edges to the closed position.

   [Diagram Description: Shows hands closing the snap edges of the sign frame over the inserted sign and cover. (See Figure 8)]